Image:Tridge rectifier.jpg
From Wikipedia, the free encyclopedia
Size of this preview: 800 × 457 pixels
Full resolution (1,314 × 750 pixels, file size: 89 KB, MIME type: image/jpeg)
"Tridge Rectifier" (three phase bridge rectifier)
This picture shows the tridge rectifier currently in use on the
Lakota rooftop mounted wind turbine currently running at 330 Dundas Street West, Toronto, Ontario.
Three phase alternating current comes in the three black wires at the upper left hand corner of the image. These are the three electrical hot wires coming down the center of a size 9 schedule 40 structural tower from the windmill. There is no neutral. There is a ground, which is the metal housing.
Leftmost, bolted to a large heatsink, there are three double diodes.
Three black wires come out the top of each double diode, and three red wires come out the bottom.
The black and red wires go to the screw terminals labelled "negative" and positive" respectively.
The screw terminals are shown rightmost in the picture.
These terminals go to a 12 volt 2000 Amp Hour battery that weighs approximately 2000 pounds, as well as to a 12 volt distribution system in the building to support a community of cyborgs, i.e. to charge 12 volt batteries as well as to run various of the 12 volt equipment that has accumulated from 30 years of wearable computing work. Such equipment includes various communications systems, Internet gateways, and other systems that must keep running regardless of whether or not there is a power failure.
This system, having separate turbine and rectifier, replaces an earlier dilapidated wind power system that was based on an automotive alternator with six diodes built into it. With the earlier system it was necessary to "hack" the circuit in order to get three phase power out of it because automobile alternators do not normally provide three phase power directly to the outside terminals.
The new system is preferable for teaching use, because the rectifier is located inside the building, allowing maintenance and research to be carried out without climbing up the mast (e.g. to change diodes, etc., which required climbing up the mast and taking down the alternator with the old system).
 |
This work is free software; you can redistribute it and/or modify it under the terms of the GNU General Public License as published by the Free Software Foundation; either version 2 of the License, or any later version. This work is distributed in the hope that it will be useful, but without any warranty; without even the implied warranty of merchantability or fitness for a particular purpose. See version 2 and version 3 of the GNU General Public License for more details. You should have received a copy of the GNU General Public License along with this program; if not, write to the Free Software Foundation, Inc., 51 Franklin St, Fifth Floor, Boston, MA 02110-1301 USA |
File history
Click on a date/time to view the file as it appeared at that time.
| Date/Time | Dimensions | User | Comment | |
|---|---|---|---|---|
| current | 16:18, 19 June 2004 | 1,314×750 (89 KB) | Glogger (Talk | contribs) | ("Tridge Rectifier" (three phase bridge rectifier)) |
- Search for duplicate files
- Edit this file using an external application
See the setup instructions for more information.
