Transverse flow effect

From Wikipedia, the free encyclopedia

This article or section needs to be wikified to meet Wikipedia's quality standards.
Please help improve this article with relevant internal links. (December 2007)

Transverse flow effect is an aerodynamic effect encountered when the helicopter moves (typically forward) through the air.

In a hover, the air above the rotor disk is being pulled down from above and is equally distributed around the rotor disk. The air is descending from above, which has the effect of reducing angle of attack.

As the helicopter starts moving into undisturbed air, a portion of the disk is in clean, unaccelerated air, while the remaining portion of the rotor disk is still working on descending air. The part of the disk working on clean air therefore sees a higher angle of attack than the portion of the disk which is working on descending air. This causes a difference in lift between the section in clean air and the section in descending air. The result is that the portion in clean air develops more lift, and the disk tilts as a result. Which way the disk tilts depends on a couple factors:

Phase lag will cause the extra lift to be seen approximately 90 degrees later in rotor rotation in semi-rigid two bladed rotor systems. Phase lag is a separate phenomenon from gyroscopic precession, which applies only to rigid systems. Rotor systems are not rigid systems since all helicopter rotors are designed to "flap" up or down as they change position around the rotor arc. This flapping counter acts dissymetry of lift in forward flight. Phase lag is a property of all rotating systems acted upon by a periodic force. For systems hinged at the axis of rotation ( in our case, a semi rigid flapping type rotor head) the phase lag is 90 degrees. For systems that are hinged at some distance from the axis of rotation (such as a fully articulated rotor head) the phase lag is less than 90 degrees. The pilot will experience either a right or left roll, depending upon whether the rotor of the helicopter rotates clockwise or counter-clockwise. Typically, an American helicopter would roll to the right during the takeoff roll, while a French or Russian helicopter would roll to the left.

Which way the helicopter rotor disk is moving in the wind will determine which part of the disk has higher lift. For instance, hovering sideways, or hovering stationary in a crosswind, the clean portion of the disk might be on the left or right, rather than the front of the rotor disk. Again, depending on which direction the rotor rotates, this might be seen as a nose pitch up or nose pitch down, a roll, or something in between.

As the helicopter accelerates into a higher airspeed, more and more of the rotor disk will be in clean air and the lift differential will decrease. At some higher airspeed the effect will disappear. In a typical single rotor helicopter, the effect can be felt to start at around 5-10 knots, increases in magnitude to a maximum around 20 knots, and decreases above that until it is almost completely gone by 40-60 knots of airspeed.