Spurline

From Wikipedia, the free encyclopedia

This article is orphaned as few or no other articles link to it.
Please help introduce links in articles on related topics. (November 2006)

The spurline is a type of radio-frequency and microwave filter with band-stop (notch) characteristics, most commonly used with microstrip transmission lines. Spurlines usually exhibit moderate to narrow-band rejection, at about 10% around the central frequency.

Spurline filters are very convenient for dense integrated circuits because of their inherently compact design and ease of integration: they occupy surface that corresponds only to a quarter-wavelength transmission line.

[edit] Structure Description

It consists of a normal microstrip line breaking into a pair of smaller coupled lines that rejoin after a quarter-wavelength distance. Only one of the input ports of the coupled lines is connected to the feed microstrip, as shown in the figure below. The grey area of the illustration is the microstrip transmission line conductor and the brown color the exposed dielectric. (This is confusing as the brownish color is generally used to represent copper):

Figure : Microstrip Spurline Notch Filter (Top View)

Where $λ g$ is the wavelength corresponding to the central rejection frequency of the bandstop filter, measured - of course - in the microstrip line material. This is the most important parameter of the filter that sets the rejection band.

The distance between the two coupled lines can be selected appropriately to fine-tune the filter. The smaller the distance, the narrower the stop-band in terms of rejection. Of course that is limited by the circuit-board printing resolution, and it is usually considered at about 10% of the input microstrip width.

The gap between the input microstrip line and the one open-circuited line of the coupler has a negligible effect on the frequency response of the filter. Therefore it is considered approximately equal to the distance of the two coupled lines.

[edit] References

C. Nguyen and K. Chang, “On the analysis and design of spurline bandstop filters,” IEEE Trans. Microw. Theory Tech., vol. 33, no. 12, pp. 1416–1421, Dec. 1985.