Spencer repeating rifle
From Wikipedia, the free encyclopedia
The Spencer repeating rifle was a manually operated lever-action, repeating rifle fed from a tube magazine with cartridges. It was adopted by the Union Army, especially by the cavalry, during the American Civil War, but did not replace the standard issue muzzle-loading rifled muskets in use at the time. The Spencer carbine was a shorter and lighter version.
Contents |
[edit] Overview
The design was completed by Christopher Spencer in 1860, and was for a magazine-fed, lever-operated rifle chambered for the .56–56 rimfire cartridge. Unlike later cartridge designations, the first number referred to the diameter of the case at the head, while the second number referred to the diameter at the mouth; the actual bullet diameter was .52 inches. Cartridges were loaded with 45 grains (2.9 g) of black powder.
To use the Spencer, a lever had to be worked to extract the used shell and feed a new cartridge from the tube. Like the Dreyse breech-loader, the hammer then had to be manually cocked in a separate action. The weapon used rimfire cartridges stored in a seven-round tube magazine, enabling the rounds to be fired one after another. When empty, the tube could be rapidly loaded either by dropping in fresh cartridges or from a device called the Blakeslee Cartridge Box, which contained up to ten tubes with seven cartridges each, which could be emptied in the magazine tube in the buttstock.
There were also .56–52, .56–50, and even a few .56–46 versions of the cartridge created, which were necked down versions of the original .56–56. Cartridge length was limited by the action size to about 1.75 inches, and the later calibers used a smaller diameter, lighter bullet and larger powder charge to increase the power and range over the original .56–56 cartridge, which, while about as powerful as the .58 caliber rifled musket of the time, was underpowered by the standards of other early cartridges such as the .50–70 and .45-70.
[edit] History
At first, conservatism from the Department of War delayed its introduction to service. However, Christopher Spencer was eventually able to gain an audience with President Abraham Lincoln, who subsequently invited him to a shooting match and demonstration of the weapon. Lincoln was impressed with the weapon, and ordered that it be adopted for production.
The Spencer repeating rifle was first adopted by the United States Navy, and subsequently adopted by the United States Army and used during the American Civil War. The South occasionally captured some of these weapons and ammunition, but, as they were unable to manufacture the cartridges because of shortages of copper, their ability to take advantage of the weapons was limited. Notable early instances of use included the Battle of Hoover's Gap (where Col. John T. Wilder's "Lightning Brigade" effectively demonstrated the firepower of repeaters), and the Gettysburg Campaign, where two regiments of the Michigan Brigade (under Brig. Gen. George Armstrong Custer) carried them at the Battle of Hanover and at East Cavalry Field.[1] As the war progressed, Spencers were carried by a number of Union cavalry and mounted infantry regiments and provided the Union army with additional firepower versus their Confederate counterparts.
The Spencer showed itself to be very reliable under combat conditions, with a sustainable rate-of-fire in excess of 20 rounds per miniute. Compared to standard muzzle-loaders, with a rate of fire of 2-3 rounds per minute, this represented a significant tactical advantage[2]. However, effective tactics had yet to be developed to take advantage of the higher rate of fire. Similarly, the supply chain was not equipped to carry the extra ammunition. Detractors would also complain that the smoke and haze produced was such that it was hard to see the enemy.[3]
In the late 1860s, the Spencer company was sold to the Fogerty Rifle Company and ultimately to Winchester. With almost 200,000 rifles and carbines made, it marked the first adoption of a removable magazine-fed infantry rifle by any country. Many Spencer carbines were later sold as surplus to France where they were used in the war against Germany in 1870.
Despite the fact that the Spencer company went out of business in 1869, ammunition was sold in the United States up to about the 1920s. Later, many rifles and carbines were converted to centerfire, which could fire cartridges made from the centerfire .50–70 brass. Production ammunition can still be obtained on the specialty market. Manufacturer Ten-X Ammunition regularly stocks centerfire .56–50 Spencer[1] in a smokeless round, a black powder substitute round and a blank cartridge for reenactments.
[edit] See also
[edit] Notes
- ^ Rummel III, George, Cavalry of the Roads to Gettysburg: Kilpatrick at Hanover and Hunterstown, White Mane Publishing Company, 2000, ISBN 1-57249-174-4.
- ^ Spencer
- ^ More on Spencer's Seven Shot Repeater
[edit] References
- Earl J. Coates and Dean S. Thomas, An Introduction to Civil War Small Arms
- Ian V. Hogg, Weapons of the Civil War
- Barnes, Cartridges of the World
- Marcot, Roy A. "Spencer Repeating Firearms" 1995
[edit] External links
- The patent drawing for the Spencer action
- Spencer's Repeaters: Some History and Shooting Tips, with information on Spencer's unique caliber designations, and how to reload for centerfire conversions
- Description and photos of Spencer rifle, serial number 3981
- Smithsonian Institute page on the Spencer rifle, mentioned the Blakeslee cartridge box
- Production information on the Spencer carbine
- Ten-X Ammunition[2] commercially manufactures ammunition and blanks for the Spencer rifles.
- www.ammo-one.com, dealer in rare ammunition, has pictures and information on Spencer cartridges .56-56, .56-52, .56-50, and .56-46