SONOS

From Wikipedia, the free encyclopedia

Computer memory types
Volatile
Non-volatile

SONOS, short for Silicon-Oxide-Nitride-Oxide-Silicon, is a type of high-performance non-volatile computer memory. It is similar to the widely used Flash RAM, but offers lower power usage and a somewhat longer lifetime. SONOS is being developed as one of a number of potential Flash replacements, and is currently used in Cypress Semiconductor's PSoC line of products.

Contents

[edit] Description

Schematic drawing of a SONOS memory cell.
Schematic drawing of a SONOS memory cell.

SONOS "cells" consist of a standard NMOS transistor with an additional layering of insulators on the gate (the transistor's "switch"). The layering consists of an oxide layer approximately 2 nm thick, a silicon nitride layer about 5 nm, and a second oxide layer with a thickness between 5 and 10 nm.

When the gate is biased positively, electrons from the source-drain circuit "above" the layer tunnel through the oxide layer and get trapped in the silicon nitride. This results in an energy barrier between the drain and the source, raising the threshold voltage Vt (the gate-source voltage necessary for current to flow through the transistor). The electrons can be removed again by applying a negative bias on the gate.

A SONOS memory device is constructed by fabricating a grid of SONOS transistors along with a small amount of control circuitry. After storing or erasing the cell, the controller can measure the state of the cell by passing a small voltage across the source-drain pair; if current flows the cell must be in the "no trapped electrons" state, which is considered to mean "0". If no current is seen the cell is in the "1" state. The needed voltages are normally about 2 V for the erased state, and around 4.5 V for the programmed state.

[edit] Comparison with Flash

Generally SONOS is very similar to Flash, but is, in theory at least, much easier to produce. Flash requires the construction of a very high-performance insulating barrier on the gate leads of its transistors, often requiring as many as nine different steps, whereas the oxide layering in SONOS can be more easily produced on existing lines.

Additionally, Flash leaks electrons through the insulator, a problem that grows worse as the size of the insulating barrier is reduced. Even with the introduction of new insulator technologies this has a definite "lower limit" around 7 to 12 nm, which means it is difficult for Flash devices to scale smaller than about 45 nm linewidths. SONOS, on the other hand, requires a very thin layer of insulator in order to work, making the gate area smaller than Flash. This allows SONOS to scale to smaller linewidth, with recent examples being produced on 40 nm fabs and claims that it will scale to 20 nm.[1] The linewidth is directly related to the overall storage of the resulting device, and indirectly related to the cost; in theory, SONOS' better scalability will result in higher capacity devices at lower costs.

Additionally, the voltage needed to bias the gate during writing is much smaller than in Flash. In order to write Flash, power is first built up in a separate device known as a charge pump, which multiplies the input voltage to between 9 V to 20 V. This process takes some time, meaning that writing to a Flash cell is much slower than reading, often between 100 and 1000 times slower. The pulse of high power also degrades the cells slightly, meaning that Flash devices can only be written to between 10,000 and 100,000 times, depending on the type. SONOS devices require much lower write power, typically 5 to 8 V, and do not degrade in the same way. SONOS does suffer from an unrelated problem, however, where electrons become strongly trapped in the ONO later and cannot be removed again. Over long usage this can eventually lead to enough trapped electrons to permanently set the cell to the "1" state, similar to the problems in Flash. However, in SONOS this requires on the order of a 100,000,000 write cycles, 1000 to 10,000 times better than Flash.

[edit] History

SONOS was first invented in the 1960s, but the semiconductor fabrication methodologies needed to develop it practically have not existed until recently.[citation needed]

Philips is one of the groups working on SONOS devices[2], and have produced small 26-bit demonstrators with excellent lifetimes at a 120 nm linewidth. It is not clear if this research is ongoing, however, given the rapid advances in Flash technology that have led to very large gains in areal density. Other groups are also working on SONOS for more specialized tasks, notably military and space systems due to its excellent radiation hardness[3].

Spansion recently announced the development of SONOS flash memory using it's MirrorBit technology[4].

A Taiwanese company, eMemory, offers SONOS-based devices in their NeoFlash technology, which is based on p-channel SONOS technology[5].

[edit] See also

[edit] References

  1. ^ Samsung unwraps 40nm "charge trap flash" device
  2. ^ Embedded non-volatile memories
  3. ^ Design Considerations in Scaled SONOS Nonvolatile Memory Devices
  4. ^ http://biz.yahoo.com/prnews/071115/aqth067.html?.v=25
  5. ^ H.M. Lee et al., "NeoFlash - true logic single poly flash memeory technology", IEEE Non-volatile Semiconductor Memory Workshop, pp. 15-16 (2006).