Single crystal

From Wikipedia, the free encyclopedia

A huge KDP crystal grown from a seed crystal in a supersaturated aqueous solution at LLNL which is to be cut into slices and used on the National Ignition Facility for frequency doubling and tripling.

A single crystal, also called monocrystal, is a crystalline solid in which the crystal lattice of the entire sample is continuous and unbroken to the edges of the sample, with no grain boundaries. The opposite of a single crystal sample is an amorphous structure where the atomic position is limited to short range order only. In between the two extremes exist polycrystalline and paracrystalline phases, which are made up of a number of smaller crystals known as crystallites. Because of a variety of entropic effects on the microstructure of solids, including the distorting effects of impurities and the mobility of crystallographic defects and dislocations, single crystals of meaningful size are exceedingly rare in nature, and can also be difficult to produce in the laboratory under controlled conditions (see also recrystallisation).

Single-crystal silicon boule.

A single-crystal quartz bar grown by the hydrothermal method

Because grain boundaries can have significant effects on the physical and electrical properties of a material, single crystals are of interest to industry, and have important industrial applications. The most notable of these is the use of single crystal silicon in the fabrication of semiconductors. On the quantum scale that microprocessors operate on, the presence of grain boundaries would have a significant impact on the functionality of field effect transistors by altering local electrical properties. Therefore, microprocessor fabricators have invested heavily in facilities to produce large single crystals of silicon.

Fabrication of single crystals usually involves the building of a crystal layer by layer of atoms. Techniques to produce large single crystals (boules) include slowly drawing a rotating "seed crystal" in a molten bath of feeder material (as in the Czochralski process and the Bridgeman technique). Some thin film deposition techniques can be used for epitaxy, forming a new layer of material with the same structure on the surface of an existing single crystal.

1 Uses
2 See also
3 Gallery
4 References

[edit] Uses

Monocrystals of silicon and other semiconductors are important for manufacture of integrated circuits.
Monocrystals of sapphire and other materials are used for lasers and nonlinear optics.
Monocrystals of fluorite are sometimes used in the objective lenses of apochromatic refracting telescopes.^{[citation needed]}
Monocrystals of metals, especially superalloys, are used for their special mechanical properties. Turbine blades of some gas turbines are made of single crystal cast superalloy.^{[citation needed]}
Monocrystals of copper (crystalline copper) are used for fine crystalline powders and hi tech wires.^{[citation needed]}
The largest Monocrystal on Earth is believed to be the center of the Earth itself, which consists of a single enormous iron crystal some 1220 km in diameter.^{[citation needed]}
Monocrystaline superconductors have superior performance characteristics to chemically identical polycrystaline superconductors.^{[citation needed]}
Monocrystaline photovoltaic cells have superior performance characteristics to chemically identical polycrystaline solar cells.^{[citation needed]}