Signal (bridge)

From Wikipedia, the free encyclopedia

In the card game of contract bridge, the partners defending against a contract may choose particular cards to play to communicate a signal.

Contents

[edit] Standard signals

This article first describes standard (traditional) signaling. A more modern alternative is "reverse" or "upside down" (see below); your partnership needs to decide which you prefer playing. There are three types of signals. The most frequently used one is attitude signal. The next frequently used one is count signal. If these two types of signals do not apply from the context, the suit preference signal is used. The table below shows the usual application of the attitude signal and count signal.

follow-suit discard
partner lead attitude attitude
declarer lead count attitude

Count signal is used only when follow-suit. In vast majority of cases the third-hand follow-suit signal is an attitude signal as shown above, but when the attitude signal does not apply, it's a count signal. Usually, it's relatively easy to recognize a signal correctly when the declarer leads -- either a count signal when follow suit, or a attitude signal when discard, and when they do not apply, it's a suit-preference signal. When your partner leads, however, it's a lot more tricky.

In addition to these three type of signals, you can read lots of valuable information from the opening lead, like the strength, the length, and the key cards of the led suit.


[edit] Attitude signal

When signaling standard attitude, a high card is encouraging and a low card is discouraging. Attitude is normally signaled when following suit to partner's led suit and when discarding on declarer's led suit.

For example, if partner leads the Ace of spades, you might signal with the nine if you held the King (requesting partner to continue the suit), or with the three if you held nothing but small cards in spades (notifying partner that a switch to another suit is likely best).

Of course, you can only signal with the cards you hold. Signaling low is easy for you, but if your lowest card is the eight, partner might have difficulty "reading" it as low. When you are signaling high, play the highest card you can afford. Having easily-readable cards to signal with is part of the luck of the deal.

Suppose declarer is drawing trumps and you are out on the third round. Your discard should be an attitude signal for partner. If you play a high-spot diamond, for example, you ask partner to lead diamonds if she should gain the lead. Normally, you would have an honor or honors in diamonds in this case. If you play a low diamond, you ask partner to not lead diamonds if she should gain the lead. Partner will usually be able to figure out which of the other suits you do like (if any).

If declarer plays yet another round of trump, you may be able to play yet another diamond. This will make it unambiguous to partner whether you are encouraging diamonds (by playing high-low) or discouraging diamonds (by playing low-high).

  • Attitude signals at notrump contracts
  • Attitude signals at trump contracts
  • Signaling with honor cards
  • When not to signal
  • Attitude signal related conventions

[edit] Count signal

The standard count signal is to play high-low with an even number of cards, and low-high with an odd number. Normally, you "give count" when following suit to declarer's led suits. This will help partner determine the distribution of the suit. See duck (bridge) for an example.

Count in the trump suit is normally inverted. Thus, high-low shows an odd number of trumps (probably three). Some partnerships (by advance agreement) signal this way only when they have a desire or ability to ruff something.

[edit] Suit preference signal

This signal is used infrequently. Often times, it is no doubt that we have only choices of two suits play. When this is the case, we use a high card means lead the higher-ranking suit and a low card means lead the lower-ranking suit. There are four common cases:

  • follow suit on partner's lead (complement to the attitude signal). For example, in situations where partner has made an opening lead and an attitude signal is not meaningful, it is preferable to indicate which of two suits to lead; such a situation arises if when dummy is displayed it has a singleton or void in the suit being led. The signal can be advantageous, since there are hands in which continuing the original suit or switching to a trump is the right thing to do. (Some players use a middle card to indicate this situation, but it can be hard to read.)
  • lead a suit for partner to ruff (for the second ruff): show the preference of the suits you want her return. Letting your partner know where your entry is in this way may allow you to give her another ruff. For example, in the each of the two hands below, your partner has led what you have reason to believe is a singleton Club against a 4H contract. After winning the ♣A you should return ♣T for the first hand and ♣2 for the second hand.
    • ♠A964 ♥T4 ♦765 ♣AT62
    • ♠765 ♥T4 ♦A964 ♣AT62
  • follow suit on declarer/dummy's lead of a long suit (complement to the count signal). When your partner has only a single honor, show which one of the dummy's side entries you prefer so your partner can return after she wins the trick. (If there is no side entry, it is a count signal to show your partner when it is best to take her trick (see duck (bridge) for an example).
  • discarding (see below)

[edit] Upside down count and attitude

Some partnerships agree in advance to play UDCA. With this agreement, the standard count and attitude signals are inverted: when signaling attitude, a low card is encouraging and a high card is discouraging; when signaling count high-low shows odd count, low-high shows even count.

Many experienced players believe UDCA is superior to standard signaling. Most importantly, it is often easier for partner to read your signals. Also, you do not have to "waste" high cards in suits you like.

Caution: UDCA, as the name states, applies to count and attitude signals only. Suit preference signals are played standard. Also, your leads (as opposed to signals) are unchanged—you still lead high from a doubleton, for example, barring another special agreement to the contrary.

As mentioned above, standard count in the trump suit is already "upside down". Experts recommend that trump signaling be the same in UDCA as standard trump signaling, that is, when playing UDCA, signal the same in all four suits.

[edit] Discarding agreements

Some partnerships agree in advance to assign special meaning to the first discard (failure to follow suit).

[edit] Lavinthal (McKenney)

With this agreement, the first discard is suit preference. You do not like the led suit, of course, and you do not like the suit discarded. Your suit preference signal tells partner which of the two remaining suits you prefer. A high card for the higher ranking of the remaining suits and a low card for the lower ranking. Known as Lavinthal in the United States, or McKenney in the UK. The potential disadvantage of this method is that you always have to give preference for one suit or other, and you may not want any switch in particular.

There is another slightly different Lavinthal used by SAYC OKBridge Style Simplified: discard of a low card of either remaining suit (i.e., excluding trumps and the suit your are out of), asks for the lower suit. For example, if hearts are trumps and your are discarding on clubs, then a low spade or diamond asks for a diamond. Discard of a high card of either remaining suit, asks for the higher suit.

[edit] Revolving Discard

As with Lavinthal, you have the possibility to request suit preference in two ways. A low discard indicates interest in the suit directly below (a low club signaling spades); a high discard signals preference for the suit directly above (a high spade signaling clubs). In a suit contract, the trump suit is skipped in reading the signal. This is felt by many to be easier to remember than Lavinthal.

[edit] Odd-Even

With this agreement, the first discard shows the following: if it is an odd spot card (three, five, seven or nine) it is encouraging in that suit; if it is a low even spot card (deuce or four), it is suit preference for the lower ranking suit of the other two suits; if it is a high even spot card (six or eight), it shows preference for the higher ranking suit. The even card often has a dual function, in that, it not only indicates suit preference but it is also a negative indication for the suit being used for the even card.

[edit] Disclosure

Declarer is entitled to know what signaling agreements you have with your partner, and you must disclose them if asked. However, you do not have to interpret any particular play. For example, if partner plays the six of clubs and you are asked what it means, you should simply say "a high club encourages clubs, a low club discourages clubs" (assuming that is your agreement). You do not have to say whether on this deal the six is encouraging or not.

Most regulating bodies in bridge also prohibit the use of encrypted signals. These signals convey a message that can only be interpreted knowing some specifics of the hands of the defenders.

[edit] Falsecarding

In general, the partner will gain more from a player's signals than declarer, so it is worthwhile to signal honestly most of the time. However, since declarer can see your signals as well, a player who gains a reputation for always giving accurate count, for example, may find information given away by their signals used to their disadvantage. So it is common practice to throw in a misleading signal now and then, hopefully when it won't matter to partner.

[edit] References

  • Woolsey, Kit (2008). Modern Defensive Signalling in Contract Bridge. Baron Barclay Bridge. ISBN 0-910791-40-6.