Sheet resistance

From Wikipedia, the free encyclopedia

The sheet resistance is a measure of resistance of thin films that have a uniform thickness. It is commonly used to evaluate the outcome of semiconductor doping, metal deposition and resistive paste printing. Examples of these processes are: doped semiconductor regions (e.g. silicon or polysilicon), and the resistors which are screen printed onto the substrates of thick film hybrid microcircuits.

The utility of sheet resistance, as opposed to resistance or resistivity, is that it is directly measured using a four-terminal sensing measurement (also known as a four-point probe measurement).

Sheet resistance is measured in ohms/square (\Omega/\square), and is applicable to two-dimensional systems where the thin film is considered to be a two dimensional entity. It is equivalent to resistivity as used in three-dimensional systems. When the term sheet resistance is used, the current must be flowing along the plane of the sheet, not perpendicular to it.

In a regular three-dimensional conductor, the resistance can be written as

R=\rho\frac{L}{A} = \rho\frac{L}{W t}

where ρ is the resistivity, A is the cross-sectional area and L is the length. The cross-sectional area can be split into the width W and the sheet thickness t.

By grouping the resistivity with the thickness, the resistance can then be written as

R = \frac{\rho}{t} \frac{L}{W} = R_s \frac{L}{W}

Rs is then the sheet resistance. Because it is multiplied by a dimensionless quantity, the units are ohms. The term ohms/square is used because it gives the resistance in ohms of current passing from one side of a square region to the opposite side, regardless of the size of the square. For a square, L = W. Therefore, R = Rs for any size square.

Image:sheet_resistance.jpg

[edit] References

[edit] General references

  • Van Zant, Peter (2000). Microchip Fabrication. New York: McGraw-Hill, 431-2. ISBN 0-07-135636-3.