RCA connector

From Wikipedia, the free encyclopedia

RCA Plugs for composite video and stereo audio

An RCA jack, also referred to as a phono connector or CINCH/AV connector, is a type of electrical connector that is commonly used in the audio/video market. The name "RCA" derives from the Radio Corporation of America, which introduced the design by the early 1940s to allow mono phonograph players to be connected to amplifiers.

For many other applications it began to replace the older jack plugs used in the audio world when component high fidelity started becoming popular in the 1950s.

The corresponding plug is called an RCA plug or a phono plug. The latter is often confused with a phone plug which refers to a TRS connector.

[edit] Uses

In the most normal usage, cables have a standard plug on each end, consisting of a central male connector, surrounded by a ring. The ring is often segmented for flexibility. Devices mount the jack, consisting of a central hole with a ring of metal around it. The ring is slightly smaller in diameter and longer than the ring on the plug, allowing the plug's ring to fit tightly over it. The jack has a small area between the outer and inner rings which is filled with an insulator, typically plastic (very early versions, or those made for use as RF connectors used ceramic).

High-quality audio grade RCA connectors.

As with many other connectors, the RCA has been adopted for other uses than originally intended, including as a power connector, an RF connector, and as a connector for loudspeaker cables. Its use as a connector for composite video signals is extremely common, but provides poor impedance matching. RCA connectors and cable are also commonly used to carry SPDIF-formatted digital audio, with plugs colored orange to differentiate them from other typical connections.

Connections are made by pushing the cable's plug into the female jack on the device. The signal-carrying pin protrudes from the plug, and often comes into contact with the socket before the grounded rings meet, resulting in loud hum or buzz if the audio components are powered while making connections. Continuous noise can occur if the plug partially falls out of the jack, breaking ground connection but not the signal. Some variants of the plug, especially cheaper versions, also give very poor grip and contact between the ground sheaths due to their lack of flexibility.

They are often color coded, yellow for composite video, red for the right channel and white or black for the left channel of stereo audio. This trio (or pair) of jacks can be found on the back of almost all audio and video equipment. At least one set is usually found on the front panel of modern TV sets, to facilitate connection of camcorders, digital cameras, and video gaming consoles. Although nearly all audio-visual connectors, including audio, composite and component video, and S/PDIF audio can use identical 75 Ω cables, sales of special-purpose cables for each use have proliferated. Varying cable quality means that a cheap line-level audio cable might not successfully transfer component video or digital audio signals due to impedance mismatch and poor shielding quality (causing SNR ratio to be too low).^{[citation needed]}

The male plug has a center pin which is 3.70 mm in diameter, and is surrounded by an outer shell which is 8.25 mm in diameter

[edit] Disadvantages

"Bullet plug" variation. Notice the hollow center conductor and the single pin point for the return signal.

One problem with the RCA jack system is that each signal requires its own wire. Even the simple case of attaching a cassette deck may need four of them, two for input, two for output. In any common setup this quickly leads to cable salad, which is made worse if one considers more complex signals like component video (a total of three for video and two for analog audio or one for digital coaxial audio). There have been numerous attempts to use combined connectors in both the audio and video world, but none of these have ever become universal – with the exception of the SCART connector, which has become very successful in Europe. For a time the 5-pin DIN plug was popular for bi-directional stereo connection between A/V equipment, but it has been entirely displaced by the phono connector on modern consumer devices. Nearly all modern TV sets, VCRs, and DVD players sold in Europe have SCART sockets. For audio signals, an RCA connection is called unbalanced, and a true balanced connection is generally preferred in certain applications because it allows for the use of long cables while reducing susceptibility to external noise.

[edit] Origin

The word phono is an abbreviation of the word phonograph, because this connector was originally created to allow the connection of a phonograph turntable to a radio receiver, utilizing the radio as an amplifier. This setup was present in most radios manufactured in the 1930s onward by the Radio Corporation of America (RCA), who later marketed a special turntable for 45 RPM records.

[edit] Color coding in consumer equipment

Plugs and sockets on consumer equipment are conventionally color-coded to aid correct connections. The standard^[1] colors for the various signals are shown below.

Note: in stereo audio applications there are combinations of either Black+Red or White+Red RCA connectors - In both cases, Red denotes Right. Purple may also be substituted by Black.

[edit] References

1. ^ Consumer Electronics Association standard CEA-863-A "Connection Color Codes for Home Theater Systems"

[edit] See also

Wikimedia Commons has media related to:

RCA connectors

• High-end audio cables