Ramsey Car Transfer Apparatus
From Wikipedia, the free encyclopedia
In railroad indusry, the Ramsey Car Transfer Apparatus (Ramsey Transfer) was a proposed device to replace bogies on railroad cars to permit transfer of a train between railroad lines with different gauge.
The Ramsey Transfer existed in a number of variations covered by several different patents. It was typically used to transfer cars between standard gauge and narrow gauge (usually three feet in width) track.
Two parallel tracks of 18 inches were set approximately nine feet apart. Between these two tracks, the standard and narrow gauge tracks descended into a pit, one from each end of the pit, overlapping in the center and having a common center line. Beams resting on trucks riding on the 18 inch gauge tracks were inserted under the car to have its trucks changed. The car was then pushed over pit, resting on the beams. This allowed the old trucks to slip off the center pins. The old trucks were pulled out of the pit and new trucks were shoved in from the opposite side. As the car passed over the opposite side of the pit, the new trucks were guided to fit on the center pins. The car now continued on its way, its load undisturbed.
It was claimed that the entire procedure could be performed in less than eight minutes. However in 1851, this would have referred to wagons without continuous brakes. More time would have been taken to deal with post 1880 wagons with continuous brakes.
[edit] See also
[edit] References
- U.S. Patent 8,259 of 1851.
- US Patent 304562 of September 1884.
