Q15X25
From Wikipedia, the free encyclopedia
Q15X25 is a communications protocol for sending data over a radio link. It was designed by amateur radio operator Pawel Jalocha, SP9VRC, to be an open communications standard. Like all amateur radio communications modes, this protocol uses open transmissions which can be received and decoded by anyone with similar equipment. Q15X25 is a form of packet radio. Anyone can design or adapt the open-source software to develop their own Q15X25 system.
Q15X25 is a digital signal processor-intensive mode designed to pass AX.25 packets on HF with speed and reliability much greater than traditional HF ARQ modems. It uses 15 QPSK modulated carriers separated by 125 Hertz, each modulated at 83.333 baud. Q15X25 uses forward error correction (FEC), and like MT63, uses time- and frequency-interleaving in order to avoid most error sources. The raw transmission data rate is typically 2500 bit/s.
Typically the DSP based receiver and transmitter modulator or codec is implemented as PC software that uses a sound card to connect directly to an SSB transceiver. Linux implementations are usually called "newpsk" or "newqpsk". MixW ( http://www.mixw.net/ ), a multipurpose communications control and digital modes package on Windows can implement Kiss and/or "TCP/IP over X.25" on either traditional 300 baud, 1200 baud and 2400 baud FSK packet "modems" implemented as DSP via sound card or over Q15X25. The "FlexNet" Windows packet software also has a newqpsk / Q15X25 option.
Anyone can listen/decode Q15X25 transmissions, but a license is required for transmission. It can be used by Radio Amateurs (Hams or in Ireland "Wireless Experimenters") to interconnect local VHF AX.25 packet networks over trans-continental distances.
Frequencies (all USB) in use are: 80 m 3585 kHz 40 m 7035 kHz 20 m 14109 kHz(MixW center about 1350 Hz higher)
[edit] See also
|
||||||||||||||
 |
This article related to amateur radio is a stub. You can help Wikipedia by expanding it. |
