Priority inversion

From Wikipedia, the free encyclopedia

In scheduling, priority inversion is the scenario where a low priority task holds a shared resource that is required by a high priority task. This causes the execution of the high priority task to be blocked until the low priority task has released the resource, effectively "inverting" the relative priorities of the two tasks. If some other medium priority task, that does not depend on the shared resource, attempts to run in the interim, it will take precedence over both the low priority task and the high priority task.

In some cases, priority inversion can occur without causing immediate harm -- the delayed execution of the high priority task goes unnoticed, and eventually the low priority task releases the shared resource. However, there are also many situations in which priority inversion can cause serious problems. If the high priority task is left starved of the resources, it might lead to a system malfunction or the triggering of pre-defined corrective measures, such as a watch dog timer resetting the entire system. The trouble experienced by the Mars lander "Mars Pathfinder"[1][2] is a classic example of problems caused by priority inversion in realtime systems.

Priority inversion can also reduce the perceived performance of the system. Low priority tasks usually have a low priority because it is not important for them to finish promptly (for example, they might be a batch job or another non-interactive activity). Similarly, a high priority task has a high priority because it is more likely to be subject to strict time constraints -- it may be providing data to an interactive user, or acting subject to realtime response guarantees. Because priority inversion results in the execution of the low priority task blocking the high priority task, it can lead to reduced system responsiveness, or even the violation of response time guarantees.

Contents

[edit] Solutions

The existence of this problem has been known since the 1970s, but there is no fool-proof method to predict the situation. There are however many existing solutions, of which the most common ones are:

Disabling all interrupts to protect critical sections
When disabled interrupts are used to prevent priority inversion, there are only two priorities: preemptible, and interrupts disabled. With no third priority, inversion is impossible. Since there's only one piece of lock data (the interrupt-enable bit), misordering locking is impossible, and so deadlocks cannot occur. Since the critical regions always run to completion, hangs do not occur. Note that this only works if all interrupts are disabled. If only a particular hardware device's interrupt is disabled, priority inversion is reintroduced by the hardware's prioritization of interrupts. A simple variation, "single shared-flag locking" is used on some systems with multiple CPUs. This scheme provides a single flag in shared memory that is used by all CPUs to lock all inter-processor critical sections with a busy-wait. Interprocessor communications are expensive and slow on most multiple CPU systems. Therefore, most such systems are designed to minimize shared resources. As a result, this scheme actually works well on many practical systems. These methods are widely used in simple embedded systems, where they are prized for their reliability, simplicity and low resource use. These schemes also require clever programming to keep the critical sections very brief, under 100 microseconds in practical systems. Many software engineers consider them impractical in general-purpose computers.
Arguably, these methods are similar to priority ceilings.
A priority ceiling
With priority ceilings, the shared mutex process (that runs the operating system code) has a characteristic (high) priority of its own, which is assigned to the task locking the mutex. This works well, provided the other high priority task(s) that try to access the mutex does not have a priority higher than the ceiling priority.
Priority inheritance
When priority is inherited, the low priority task inherits the priority of the highest priority task waiting for its shared resources, thus stopping the medium priority task from pre-empting the high priority task.

[edit] See also

[edit] References

  1. ^ What Really Happened on Mars by Glenn Reeves of the JPL Pathfinder team
  2. ^ Explanation of priority inversion problem experienced by Mars Pathfinder

[edit] External links