Manchester-Sheffield-Wath electric railway
From Wikipedia, the free encyclopedia
The Manchester-Sheffield-Wath electric railway was an early electrification scheme on British railways. The route featured long ascents on both sides of the Pennines with the long Woodhead Tunnel at its central summit close to the Woodhead pass. This also led to the route being called the Woodhead Line.
Contents |
[edit] The Route
See also: Manchester-Glossop Line
The main route ran from Manchester London Road (later Manchester Piccadilly) over the Pennines, through the Woodhead Tunnel to Penistone, where the Wath line split. The main line then proceeded through Sheffield Victoria Station and on to Rotherwood exchange sidings. The Wath line ran from Penistone to Wath marshalling yard in the heart of the South Yorkshire coalfields.
Minor electrified branches off the main line ran to the locomotive depot at Reddish, Glossop (for local passenger trains), Dewsnap sidings (all at the Manchester end) and Tinsley Marshalling Yard (at the Sheffield end).
[edit] Electrification
Following developments with electric traction in the USA, the Great Central Railway (GCR) first considered the electrification of the line prior to World War I. No detailed plans were drawn up, but by the 1920s the high levels of heavy freight traffic made steam operation increasingly problematic. Things were interrupted by the 1923 grouping of the railways, which saw the GCR absorbed into the London and North Eastern Railway (LNER).
The operational problems remained and so the LNER restarted the project and detailed planning for the electrification commenced in the 1930s. The system was to be electrified at 1,500V DC, similar to the Dutch style of electrification that had also been used on the LNER's Newport-Shildon line. This system had the advantage that regenerative braking could easily be employed; this provided braking traction by allowing an electric locomotive's motors to act as brakes, thus assisting with control of heavy freight trains when running downhill. The power generated by a descending train's braking action was fed back to the overhead lines and either used by other trains requiring power in the same block of line, or dissipated as heat in resistive loads at the electrical sub-stations.
Some gantries for the overhead wires were erected and a prototype locomotive was constructed. However the Depression and World War II intervened. The prototype locomotive was loaned to the Netherlands immediately after World War II to assist in working the war-damaged railways there; in the process of this it acquired the nickname "Tommy" - which later, after repatriation to Britain, was used officially.
In 1948 the assets of the LNER were nationalised as a part of British Railways. Nearly 30 years had elapsed and still the operational problems remained, so money was made available to complete the electrification project. By now the state of the original Woodhead tunnels meant that a new twin-track tunnel had to be built to replace the two original single-track bores. New electric locomotive facilities were built at Reddish, Darnall and Wath, and two classes of locomotive were built at Gorton Works, Manchester, exclusively for the line. These were the EM1 (Class 76) Bo+Bo (the + signifiying that the bogies were articulated) mixed-traffic locomotives and seven larger EM2 (Class 77) Co-Co locomotives for express passenger services.
However, to save on costs, the Cheshire Lines Committee (CLC) loop line into Manchester Central station was not electrified, as was originally in the plan: Manchester-bound passenger trains would terminate at London Road (later Piccadilly), while those few passenger trains destined for further afield would change locomotives at Guide Bridge.
The Wath to Penistone section was the first to be energised on 2 February 1952. Completion of the main line was delayed until 1954 by a collapse in the new Woodhead tunnel, and also by the decision to completely re-signal the whole main line with colour-light signals after sighting problems with the semaphore signals on the Wath branch. On 30 May 1954 electric trains began running through the tunnel and the Manchester to Penistone section was fully energised on 14 June. The Sheffield Victoria to Penistone section followed on 20 September 1954. At this time the system had its official opening despite not being fully complete: the final few miles from Sheffield Victoria to the system's eastern extremity at Rotherwood was declared open on 3 January 1955.
The benefits of electrification were immediately apparent: Sheffield to Manchester expresses now completed the journey in 56 minutes as opposed to 65 minutes with steam traction; an 850 ton coal train took a mere 66 minutes between Wath and Dunford Bridge as opposed to nearly two and a half hours powered by steam.
The Worsborough incline was a formidable feature on the Wath to Penistone section. This line was opened east of Silkstone in 1880 to alleviate congestion at Barnsley. Although nominally 1 in 40, colliery subsidence had made sections of the bank much steeper. The difficulty in operating this steeply-graded section (which included the two Silkstone tunnels) with steam traction was a key reason for electrification. Prior to electrification a unique powerful Garratt locomotive was built to act as a banker for this section of line, otherwise the normal mode of operation was for two or sometimes even three bankers for the Worsborough incline plus a pilot locomotive to assist from Wath to Dunford Bridge. Even with five locomotives, heavy trains had slowed to a walking pace by Silkstone. After electrification, much heavier coal trains could be handled up the bank; however problems with unfitted trains running away on the downgrades west of the Pennines restricted weights on such trains. In later years MGR (Merry-Go-Round) coal trains, running direct from pit to power station became the main traffic with the coal carried in block trains of 30, 32-tonne capacity air-braked wagons. These were normally double-headed by two Class 76 locomotives to their destination with two additional Class 76s banking at the rear from Wombwell to Silkstone. This was the only section of railway in the UK to be regularly operated by four locomotives per train. A "Clearcall" intercom system (via the overhead electric wires) was developed to allow the crews of the front and rear locomotives to communicate.
The purpose-built power control centre for the line was adjacent to Penistone station. The building still stands, but has been adapted for alternative commercial use.
In 1965 the scheme was extended to take in the brand new Tinsley Marshalling Yard in Sheffield. The locomotive facilities at the Sheffield end of the line were moved from Darnall to the new Tinsley depot. The overhead line equipment on this section was designed to be easily convertible to 25kV AC electrification, which by now had been accepted as the standard overhead electrification system for BR.
[edit] Closure
Electric trans-Pennine passenger services lasted just 16 years. The Beeching Report had specified that only one Manchester-Sheffield route should stay open to passengers and that route would be Woodhead. However local opposition to the closure of the alternative Hope Valley route, the high cost of providing an electrified link into Sheffield Midland station as Sheffield Victoria was slated for closure, and the impending opening of the massive Fiddlers Ferry Power Station requiring even more trans-Pennine freight train paths from the South Yorkshire Coalfield, all conspired against the Woodhead line which thus closed to passengers on in on 5 January 1970. A local electric service remained at the Manchester end of the line and the Sheffield - Penistone service was left in the hands of diesel trains. The Class 77 express passenger train locomotives were sold to the Netherlands Railways, becoming NS Class 1500.
By 1981 freight traffic had declined to extent that the route was closed; only the Manchester-Glossop/Hadfield local passenger trains were left running. British Rail claimed that the cost of replacing the out-of-date and non-standard equipment on the main section of the line was prohibitive. All but one of the remaining Class 76 locomotives were scrapped. The Wath branch was rapidly lifted between Wombwell Main Junction and West Silkstone Junction. As a part of the closure agreement, the track on the Sheffield-Penistone-Hadfield section of the route was left in place for five years. 1986 saw much of the remaining track lifted, except for the sections in the vicinity of Penistone station (which remained open for Sheffield-Huddersfield trains), and east of Deepcar which remained for both freight and passenger traffic in the Sheffield area.
In December 1984 the remaining equipment at the Manchester end of the line was modified to the by now standard 25kV AC, thus ending the use of 1,500V DC overhead electrification on British Rail. The Class 506 were withdrawn at the same time, being replaced by Class 303 EMUs from the Glasgow area. The line is now operated by Class 323 EMUs.
[edit] Re-opening?
The majority of the route has been converted to public foot, cycle and bridle paths, the only major blockage being the Stocksbridge Bypass which crosses the route on an embankment built directly over the railway alignment. Thus the majority of the route is protected for possible reopening. Indeed, in the early 21st century there have been several projects mooted to re-open the route as a trans-Pennine connection between Manchester and Sheffield, one as a non-electrified regional passenger route, and one as an electrified long-haul freight and passenger route; however, none of these has yet got beyond the drawing board.
[edit] See also
[edit] External links
- The Woodhead Site
- Route diagram British Transport Commission,1954