FS Class E424
From Wikipedia, the free encyclopedia
 A E424N in Catania with the recent XMPR livery |
|
| Power type | Electric |
|---|---|
| Builder | Breda, Off. Savigliano, Off. Reggiane/Ercole Marelli, OM/CGE, Ansaldo, TIBB |
| Build date | 1943-1951 |
| UIC classification | Bo-Bo |
| Wheel diameter | 1.250 m |
| Wheelbase | 7.350 m between bogies 3.150 m between axles in each bogie |
| Length | 15.540 m |
| Locomotive weight | 72 tons |
| Electric system(s) | 3,000 V DC |
| Traction motors | DC series |
| Transmission | 19/65 gear ratio |
| Top speed | 120 km/h |
| Power output | 1,500 kW |
| Tractive effort | 168 kN |
| Career | FS Trenitalia |
| First run | 1943 |
| Disposition | In service |
The FS E424 is a class of Italian railways electric locomotives. They were built in 1943-1951 and are still in service, tough near their career ending.
Contents |
[edit] History
A design for a small multi-service Bo-Bo locomotive, with speed up to 90 km/h, had been devised by Giuseppe Bianchi as early as in the 1930s, but the project had been halted by the introduction of the E326 and E428. After the realization of the 6-axle E636, it was however decided to revamp the project by adapting to it some solutions already in use on the E636 (engines, bogies, suspension etc).
Breda workshop provided the three prototypes of E424 in 1943-1944. Mass production, however, could begin only after the end of World War II, part of the founds provided by the United Nation Relief and Rehabilitation Administration program.
[edit] Series
The locomotives have been built in four series starting from year 1943:
- 001-003, prototype units with 32R-200 motors, 21/65 gear ratio, max speed 100 km/h and 2 field shunts; unit 003 had 20/65 gear ratio, for a maximum speed of 120 km/h, and also had compound-type motors (model 92-250).
- 004-013, compound-type 92-250 motors (as unit 003), max speed 100km/h, 19/65 gear ratio.
- 014-038 and 057-078: units from 017 to 020 plus unit 022 and 024 were identical to units 001/2; units 014, 023, 025, 057 and 060 had 19/65 gear ratio that enabled the locomotives to reach 120 km/h; all the others had 92-250 motors, 2 field shunts, 16/65 gear ratio for a max speed of 100 km/h. Units from 039 to 056 and from 079 to 158 had the same motors and gear ratio as the latters, but 5 field shunts, except for unit 136 that had 19/65 gear ratio (max speed 120 km/h). Unit 068 was transformed, from November 1954 to may 1974, into unit E434-068: this unit had 4 double 82-333 motors, 2 shunts and 110 km/h-able 20/69 gear ratio; they have been used as experiments for the following FS Class E646 locomotives.
- Series 200 units: Starting from 1986, to 1993, 105 units have received an automatic fire extinguishing system, anti-slip device, red and green lights and the 78-wire cable to permit remote control for use with commuter trains, and maximum speed was raised to 120 km/h. These units are also referred to as E424N, where "N" stands for "Navetta" (push-pull); also, number 200 has been added to units' serial numer (I.e. E424.116 became E424.316).
[edit] Technique
Class E424, having DC type motors, and like all the Italian locomotives of the time, is a rheostatic-type locomotive; on start, a rheostat is connected in series to the motors and is gradually excluded as speed builds up allowing more current to flow to the motors; but unlike other rheostatic locomotives of that time, this is not achieved via the characteristic lever (Maniglione), but through an automatic system, called Avviatore Automatico, derived from contemporary first-generation ALe 790/880/883 EMUs.
The driver simply selects the combination (series or parallel), and the relative rheostat contactors are automatically and gradually closed by this system; in case of failure, the driver can manually rotate an apposite wheel (that also usually rotates automatically as the system advances) to proceed with the exclusion.
When the rheostat is completely excluded for the series combination, field shunts can be inserted, or the driver can proceed to parallel combination, making a transition, which is handled by a device called "CEM" that automatically combines the motors (closing varius contactors) accordingly.
Originally more than one units could be coupled and be remote commanded by the first locomotive using a system called Commando Multiplo; on the central part of the cab there also was a door that enabled the crew to pass from one locomotive to another in case of problems. However, safety issues, and the not perfect reliability of this system (there were no instruments indicating the status of the slave locomotive, so it wasn't certain if it correctly made a transition of not, for example), made it to be abandoned and then dismounted.
11 units received compound-type motors, enabling a very fine speed control, in a range included between 25 and 50 km/h in series combination, and 50 - 100 km/h in parallel.
[edit] See also
[edit] External links
- Video of a locomotive traction test (Prova a vuoto); is clearly visible the wheel of Avviatore Automatico rotating
- Detailed history of the group (in italian)
|
|||||
