Flame Programmer

From Wikipedia, the free encyclopedia

A flame programmer is an electrical, electro-mechanical, or electronic device used to program the safe lighting of fuel burning equipment, as well as the safe shut-down of the flame when it is not needed.

These programmers are made with different time sequences to accommodate very small household furnaces to mammoth industrial steam boilers and many other fuel burning processes in industry.

Contents 1 A Typical Cycle 1.1 Pre-purge 1.2 Pilot Trial 1.3 Main Flame Trial 1.4 Run 1.5 Post purge

[edit] A Typical Cycle

[edit] Pre-purge

During pre-purge, the combustion air fan is started and the dampers are opened to allow fresh air into the combustion chamber and exhaust any other gases or residual fuel air mixtures.

[edit] Pilot Trial

In the pilot trial, the pilot solenoid is opened and the ignition transformer is turned on. The fuel is lit to make sure the pilot flame stays lit. There is a flame detection device that will shut down the the fuel valve if the flame fails or goes out

[edit] Main Flame Trial

With the pilot still burning, the main burner valves are opened and the main flame is lit. The flame detection device here will also shut-down or close all the fuel valves if the flame is extinguished.

[edit] Run

The pilot valve is shut and the main burner is left on and burning. The flame detector remains operational to kill the fuel valves if the flame should fail.

[edit] Post purge

When the flame is no longer needed, the fuel valves are shut and the combustion air fan is left running to clear the combustion chamber of all unburnt fuel and products of combustion. The combustion air fan is shut down after a period of time.