DOT 5

From Wikipedia, the free encyclopedia

This article or section has multiple issues. Please help improve the article or discuss these issues on the talk page.

This article does not cite any references or sources. (June 2008) Please help improve this article by adding citations to reliable sources. Unverifiable material may be challenged and removed.

DOT 5 is one of several designations of automotive brake fluid, denoting a particular mixture of chemicals imparting specified ranges of boiling point.

DOT 5 is a silicone-based brake fluid. It is NOT compatible with any polyethylene glycol based fluids. Mixing DOT 5 with other types of brake fluids will start a chemical reaction that will cause solids to precipitate out of the mixture and inhibit proper brake system function.

Unlike polyethylene glycol based fluids, it is not hygroscopic, however this means that instead of being dissolved, any water in the system will eventually find its way to the lowest point in the brake line, corroding it, and potentially boiling and causing brake failure. Since it does not attract moisture, there is no way this will occur unless you are careless in cleaning out of the old fluid. Its major advantage over other forms of brake fluid is silicone will exhibit a more stable viscosity index in extreme temperatures, which is why the US Army likes silicone fluids. It is widely used in the antique automobile arena as well as it will not damage paint. From a lubrication standpoint, there is no appreciable difference.

Check with the manufacturer of your vehicle to see if this voids your warranty

If you do decide to make this switch, be careful. You will have to completely flush you entire brake system of the DOT 3/4 before filling with DOT 5. Flushing with mineral spirits is enough to cause a complete system failure in a short time. In fact the introduction of any petroleum based products such as motor oil, power steering fluid, mineral oil (baby oil) even in small quantities will cause failure. The only way to properly flush this is with a brake cleaner that does not leave a residue.

In order to flush the system properly, every component must be removed and cleaned individually, then lubricated with the new DOT 5 and reassembled. You will also need to check with the manufacturer of your vehicle to see if this voids your warranty. This is the perfect time to see if any parts are worn and replace them accordingly. If done properly and no moisture is introduced into the system, you will not have to replace the internal components of your system again.

The factual accuracy of this section is disputed. Please see the relevant discussion on the talk page.(April 2008)

A note on DOT 3/4/5.1. The worst thing for your system is moisture, and dot 3 or 4 or 5.1 attract this. They have inhibitors which turn the fluid golden^{[citation needed]} and then to a light brown^{[citation needed]} before they are used up and the fluid needs to be flushed. The fluid should be checked for color and if it's darker than honey^{[citation needed]}, flushed and replaced. If it's black you really need to do a complete teardown of the system and see what has corroded and replace it before continuing^{[citation needed]}.

{{***Someone with the proper background needs to add that the Silicone 5 Brake Fluid will also absorb an amount of air in solution. This can and has caused the racing fraternity to shun the DOT5 due to fading. The water moisture will not change states from water to steam under the high pressures of braking but will instantly change state to steam after the brakes are released.***}} This entry is meant to elicit an entry from a qualified person.

DOT 4	Brake fluids			DOT 5.1

To comply with Wikipedia's quality standards, this article may need to be rewritten. Please help improve this article. The discussion page may contain suggestions.