Clam digging
From Wikipedia, the free encyclopedia
fishing |
---|
gathering |
clam digging |
pearl diving |
ama divers |
abalone |
scallops |
noodling |
trout tickling |
trout binning |
flounder tramping |
|
techniques |
|
Clam digging is a common means of harvesting clams from below the surface of the tidal mud flats where they live. It is done both recreationally (for enjoyment or as a source of food) and commercially (as a source of income). Commercial digging is colloquially referred to as clamming, and is done by a clammer.
Amateur clam digging is often done using a straight long-handled spading fork or a spading shovel.
Commercial clamming for the larger surf and Quahog clams (soup clams) is primarily done offshore, via mechanical dredging. To harvest cultivated clam beds, aquaculturalists often use a much smaller version (hand pulled) of the offshore dredge. Another form of commercial clamming is done from a flat decked boat using a clamrake with a telescopic handle. The head of these rakes have long tines attached to a "basket-like" cage in which the clams are collected.
In the Minas Basin area of Nova Scotia digging for soft-shelled clams is usually done with a clam hack, a spading fork with its short handle bent perpendicularly away from the fork's head. A digger typically uses the hack by grasping the spine of the prongs in one hand and the handle of the fork in the other to push the hack down into the mud, clay, or sand and then pull it up and towards him/herself. This digging action opens up the soil to expose the clams. Those clams legally long enough (44 mm in Nova Scotia) are then taken by hand and put into a peck-size (9 litre) bucket used for measuring the volume of clams collected.
Clam digging in Maine is done using a "clam hoe" (a pitchfork with the handle cut off about 18" from the tines then bent about 70 degrees) and a "roller" (a half? bushel basket built using wood lathes or wire mesh) and hip waders (boot that extend up to the top of the legs).
Another popular method for bay clamming is the use of "tongs" from a boat. These devices function like the scissor-handled posthole diggers with the exception that you contract or squeeze the tongs moving the teeth thru the bottom and feeling the ping of the clams going in the basket, very unlike the expanding motion of a post hole digger, used for digging fence post holes. Tongs appear very much like two clamrakes with teeth hinged like scissors.
In the USA, "clam diggers" is one of several possible names for shorter pants or three quarter pants.
|