Buck and ball

From Wikipedia, the free encyclopedia

Buck and ball was a common load for muzzle-loading muskets, and was very commonly used into the early days of the American Civil War. The load consisted of a full caliber round lead ball combined with three buckshot pellets.

1 Construction
2 Purpose
3 Use
4 References

[edit] Construction

Buck and ball was issued in paper cartridges that combined the projectiles with the black powder propellant charge to facilitate rapid loading of the weapon. The buckshot would set in front of the ball, so that the ball would act as a gas seal for the buckshot. Like any other paper cartridge, the rear of the cartridge would be torn open to expose the powder, which would be loaded, and the remaining paper, balls, and buckshot would be rammed down on top.

[edit] Purpose

The intent of the buck and ball load was to combine the devastating impact of the full-size (normally .69 caliber) ball with the spreading pattern of a shotgun, and served to greatly improve the hit probability of the smoothbore musket used in combat, especially at closer ranges, where the buckshot would retain significant energy.

Claud E. Fuller, in his book The Rifled Musket (New York: Bonanza Books, 1958) shows tests of a rifled musket firing Minie balls, and a smoothbore musket firing round ball and buck and ball rounds at various ranges. At ranges of 200 yards (180 meters) and under, the buck and ball from the smoothbore musket, while less accurate than the rifled musket, actually produces a greater number of hits due to the greater number of projectiles; 37 of 50 Minie balls, vs. 18 of 50 balls and 31 of 150 buckshot, for a total of 49 hits in 50 shots. Beyond this range, the buckshot will have lost sufficient energy to become ineffective due to its lower ballistic coefficient.

[edit] Use

Perhaps the most famous proponent of the buck and ball loading was George Washington, who encouraged his troops to load their muskets with buck and ball loads during the American Revolution. The buck and ball load was standard issue throughout the Seminole Wars of 1815 - 1845. With the advent of general issue rifled muskets in the American Civil War, the buck and ball loading began to fade from use, though it did see action in the remaining inventory of smoothbore muskets. The buck and ball load has been replaced in current military inventories by standard buckshot loadings in the combat shotgun [1].