Beam tetrode
From Wikipedia, the free encyclopedia
The problem of secondary emission in the tetrode tube (valve) was solved by Philips/Mullard with the introduction of a suppressor grid to produce the pentode construction. Since Philips held a patent on this design, other manufacturers were keen to produce pentode type tubes without infringing the patent.
In the UK, EMI produced and patented an alternate design. Their design had the following features (compared to the normal pentode).
- The control and screen grids were wound so that the pitches were the same and the wires were in alignment (the pentode used different pitches).
- A pair of beam forming plates was added at the two ends of the oval grid structure to focus the electron stream into a pair of beams 180 degrees apart (the pentode added a third grid). These plates are normally connected to the cathode.
The design is today known as the beam tetrode and historically was also referred to as a kinkless tetrode; since it is a four electrode device without the negative resistance kink in the characteristic plate current vs plate voltage curves of a true tetrode. Some authorities, notably outside the United Kingdom, argue that the beam plates constitute a fifth electrode.
The EMI design had the following advantages compared to the pentode.
- The screen grid current was about 5-10% of the plate (anode) current compared with about 20% for the pentode, thus the beam tetrode was more efficient
- The design introduced significantly less third harmonic distortion into the signal than did the pentode.
- The design produced a greater output power compared with a similar pentode.
The beam tetrode was not without its disadvantages.
- It had a higher intermodulation distortion than the pentode, though this could be eliminated with the application of negative feedback, or (more usually) adopting an ultra-linear design in a push-pull circuit. This connection links the screen grids to taps on the output transformer.
- The beam tetrode required a higher control grid voltage than the pentode and thus required a higher gain driver stage preceding it.
- The beam tetrode had a tendency to oscillate if the circuit was not designed properly.
The MOV valve company (who half owned EMI) considered the design too difficult to manufacture. As MOV had a design share agreement with RCA of America, the design was passed to that company. RCA had the resources to produce a workable design - the result was the famous 6L6. Not long after, the beam tetrode appeared in a variety of offerings, but for power audio purposes, the best examples were produced by the MOV company - the KT66 and later the KT88. This latter tube was never bettered, and both are still manufactured today for the more discerning audiophiles (but not by MOV).
Interestingly, many tubes that are described as pentodes actually turn out to be beam tetrodes. The ubiquitous Mullard EL34 (6CA7) although manufactured by Mullard as a pentode was also produced by many manufacturers around the world, either as a beam tetrode or as a true pentode.
Even Philips/Mullard themselves were not immune. Several examples of Mullard marked ECL82s (a signal triode and low power pentode intended for single ended operation) have turned out to be triode/beam tetrodes.
The most common Beam tetrode of all time was probably the 25L6, 35L6, and 50L6, and their miniature versions the 50B5 and 50C5 found in millions of All American Five AM radio receivers.
The beam tetrode produces the lowest distortion of this class of tube by producing significantly less third harmonic distortion; lower intermodulation distortion when used in ultralinear mode. Second harmonic distortion is automatically cancelled in a push-pull design. The beam tetrode also lends itself to being operated as a triode (by connecting its screen grid to its plate), and in this mode functions more efficiently than a pentode operated in the same manner.