Bacterial growth

From Wikipedia, the free encyclopedia

Growth is shown as L = log(numbers) where numbers is the number of colony forming units per ml, versus T (time.)
Growth is shown as L = log(numbers) where numbers is the number of colony forming units per ml, versus T (time.)

Bacterial growth is the division of one bacterium into two idential daughter cells during a process called binary fission. Hence, local doubling of the bacterial population occurs. Both daughter cells from the division do not necessarily survive. However, if the number surviving exceeds unity on average, the bacterial population undergoes exponential growth. The measurement of an exponential bacterial growth curve in batch culture was traditionally a part of the training of all microbiologists; the basic means requires bacterial enumeration (cell counting) by direct and individual (microscopic, flow cytometry[1]), direct and bulk (biomass), indirect and individual (colony counting), or indirect and bulk (most probable number, turbidity, nutrient uptake) methods. Models reconcile theory with the measurements [2].

In autecological studies, bacterial growth in batch culture can be modeled with four different phases: lag phase (A), exponential or log phase (B), stationary phase (C), and death phase (D).

  1. During lag phase, bacteria adapt themselves to growth conditions. It is the period where the individual bacteria are maturing and not yet able to divide. During the lag phase of the bacterial growth cycle, synthesis of RNA, enzymes and other molecules occurs.
  2. Exponential phase (sometimes called the log phase)is a period characterised by cell doubling.[3] The number of new bacteria appearing per unit time is proportional to the present population. If growth is not limited, doubling will continue at a constant rate so both the number of cells and the rate of population increase doubles with each consecutive time period. For this type of exponential growth, plotting the natural logarithm of cell number against time producing a straight line. The slope of this line is the specific growth rate of the organism, which is a measure of the number of divisions per cell per unit time.[3] The actual rate of this growth (i.e. the slope of the line in the figure) depends upon the growth conditions, which affect the frequency of cell division events and the probability of both daughter cells surviving. Exponential growth cannot continue indefinitely, however, because the medium is soon depleted of nutrients and enriched with wastes.
  3. During stationary phase, the growth rate slows as a result of nutrient depletion and accumulation of toxic products. This phase is reached as the bacteria begin to exhaust the resources that are available to them.
  4. At death phase, bacteria run out of nutrients and die.

This basic batch culture growth model draws out and emphasizes aspects of bacterial growth which may differ from the growth of macrofauna. It emphasizes clonality, asexual binary division, the short development time relative to replication itself, the seemingly low death rate, the need to move from a dormant state to a reproductive state or to condition the media, and finally, the tendency of lab adapted strains to exhaust their nutrients.

In reality, even in batch culture, the four phases are not well defined. The cells do not reproduce in synchrony without explicit and continual prompting (as in experiments with stalked bacteria [4]) and their logarithmic phase growth is often not ever a constant rate, but instead a slowly decaying rate, a constant stochastic response to pressures both to reproduce and to go dormant in the face of declining nutrient concentrations and increasing waste concentrations.

Batch culture is the most common laboratory growth environment in which bacterial growth is studied, but it is only one of many. It is ideally spatially unstructured and temporally structured. The bacterial culture is incubated in a closed vessel with a single batch of medium. In some experimental regimes, some of the bacterial culture is periodically removed to a fresh sterile media is added. In the extreme case, this leads to the continual renewal of the nutrients. This is a chemostat also known as continuous culture. It is ideally spatially unstructured and temporally unstructured, in an equilibrium state defined by the nutrient supply rate and the reaction of the bacteria. In comparison to batch culture, bacteria are maintained in expodential growth phase and the grow growth rate of the bacteria is known. Related devices include turbidostats and auxostats.

Bacterial growth can be suppressed with bacteriostats, without necessarily killing the bacteria. In a synecological, a true-to-nature situation, where more than one bacterial species is present, the growth of microbes is more dynamic and continual.

Liquid is not the only laboratory environment for bacterial growth. Spatially structured environments such as biofilms or agar surfaces present additional complex growth models.

[edit] References

  1. ^ Skarstad K, Steen HB, Boye E (1983). "Cell cycle parameters of slowly growing Escherichia coli B/r studied by flow cytometry". J. Bacteriol. 154 (2): 656–62. PMID 6341358. 
  2. ^ Zwietering M H, Jongenburger I, Rombouts F M, van 'T Riet K (1990). "Modeling of the Bacterial Growth Curve". Applied and Environmental Microbiology 56 (6): 1875-1881. 
  3. ^ a b "http://www.ifr.ac.uk/bacanova/project_backg.html". Retrieved on May 7, 2008
  4. ^ Novick A (1955). "Growth of Bacteria". Annual Review of Microbiology 9: 97-110. doi:10.1146/annurev.mi.09.100155.000525. 

[edit] External links

This article includes material from an article posted on 26 April 2003 on Nupedia; written by Nagina Parmar; reviewed and approved by the Biology group; editor, Gaytha Langlois; lead reviewer, Gaytha Langlois ; lead copyeditors, Ruth Ifcher. and Jan Hogle.