Tiltrotor

From Wikipedia, the free encyclopedia

The Bell-Boeing V-22 Osprey, the best known example of a tiltrotor aircraft.
The Bell-Boeing V-22 Osprey, the best known example of a tiltrotor aircraft.

A tiltrotor aircraft combines the vertical lift capability of a helicopter with the speed of a turboprop airplane.

Contents

[edit] Overview

As the name implies, a tiltrotor aircraft uses tiltable (rotating) propellers, or proprotors, for lift and propulsion. For vertical flight the proprotors are angled to direct their thrust downwards, providing lift. In this mode of operation the craft is essentially identical to a helicopter. As the craft gains speed, the proprotors are slowly tilted forward, eventually becoming perpendicular to the ground. In this mode the wing provides the lift, and the wing's greater efficiency helps the tiltrotor achieve its high speed. In this mode, the craft is essentially a turboprop aircraft.

A tiltrotor aircraft is different from a tiltwing, inwhich the whole wing is rotated, rather than just the rotors on a tiltrotor.

[edit] Controls

In vertical flight, the tiltrotor uses controls very similar to a twin or tandem-rotor helicopter. Yaw is controlled by tilting its rotors in opposite directions. Roll is provided through differential power or thrust. Pitch is provided through rotor cyclic or nacelle tilt. Vertical motion is controlled with conventional rotor blade pitch and either a conventional helicopter collective control lever (as in the Bell/Agusta BA609) or a unique control similar to a fixed wing engine control called a thrust control lever (TCL) (as in the Bell-Boeing V-22 Osprey).[citation needed]

[edit] Speed and payload issues

The tiltrotor's advantage is significantly greater speed than a helicopter. In a helicopter the maximum forward speed is defined by the turn speed of the rotor; at some point the helicopter will be moving forward at the same speed as the spinning of the backwards-moving side of the rotor, so that side of the rotor sees zero or negative airspeed, and begins to stall. This limits modern helicopters to cruise speeds of about 150 knots (277 km/h.) However, with the tiltrotor this problem is avoided, because the proprotors are perpendicular to the motion in the high-speed portions of the flight regime (and thus never suffering this reverse flow condition), meaning that the tiltrotor has relatively high maximum speed - over 300 knots (560 km/h) has been demonstrated in the two types of tiltrotors flown so far, and cruise speeds of 250 knots (460 km/h) are achieved.[citation needed]

This speed is achieved somewhat at the expense of payload. As a result of this reduced payload, a tiltrotor does not exceed the transport efficiency (speed times payload) of a helicopter.[1] Additionally, the tiltrotor propulsion system is more complex than a conventional helicopter due to the large, articulated nacelles and the added wing; however, the improved cruise efficiency and speed improvement over helicopters is significant in certain uses. Speed and, more importantly, the benefit to overall response time is the principal virtue sought by the military forces that are using the tiltrotor. Tiltrotors are inherently less noisy in forward flight (airplane mode) than helicopters. This, combined with their increased speed, is expected to improve their utility in populated areas for commercial uses and reduce the threat of detection for military uses. Tiltrotors, however, are typically as loud as equally sized helicopters in hovering flight.

Tiltrotors also provide substantially greater cruise altitude capability than helicopters. Tiltrotors can easily reach 20,000 ft or more whereas helicopters typically do not exceed 10,000 ft altitude. This feature will mean that some uses that have been commonly considered only for fixed-wing aircraft can now be supported with tiltrotors without need of a runway. A drawback however is that a tiltrotor suffers considerably reduced payload when taking off from high altitude. Based on the approved flight manuals for each, the 50,000 lb class (22,600 kg) V-22 Osprey carries the same payload as the 22,000 lb class (9,950 kg) UH-60L Black Hawk helicopter when both operate from a landing zone at 10,000 feet above sea level.[citation needed]

[edit] Tiltrotor aircraft development

Research into tiltrotor technology began in the 1940s, with the Bell XV-3. Built in 1953, this experimental aircraft flew until 1966, proving the fundamental soundness of the tiltrotor concept and gathering data about technical improvements needed for future designs. In 1972, with funding from NASA and the U.S. Army, Bell Helicopter Textron started development of the XV-15, a twin-engine tiltrotor research aircraft. Two aircraft were built to prove the tiltrotor design and explore the operational flight envelope for military and civil applications.[2]

In 1981, using experience gained from the XV-3 and XV-15, Bell and Boeing Helicopters began developing the V-22 Osprey, a twin-turboshaft military tiltrotor aircraft for the U.S. Air Force and the U.S. Marine Corps.[2]

Bell, teamed with AgustaWestland, is developing the commercial BA609, and the firm has also developed a tiltrotor unmanned aerial vehicle (UAV), the TR918 Eagle Eye.

Bell and Boeing have teamed up again to perform a conceptual study of a larger Quad TiltRotor (QTR) for the US Army's Joint Heavy Lift (JHL) program. The QTR is a larger, four rotor version of the V-22 with two tandem wings sets of fixed wings and four tilting rotors.

A related technology evelopment is the tiltwing. Two particularly successful designs were the Canadair CL-84 Dynavert and the LTV XC-142. Both aircraft were technical successes, but neither entered production due to other issues.

[edit] List of tiltrotor aircraft

[edit] References

[edit] External links

[edit] Related content

 

Comparable aircraft

 

 

See also