Supercapacitor

From Wikipedia, the free encyclopedia

You have new messages (last change).
Supercapacitors MC anc BC series (up to 3000 farad capacitance) produced by Maxwell Technologies
Supercapacitors MC anc BC series (up to 3000 farad capacitance) produced by Maxwell Technologies

A supercapacitor or ultracapacitor is an electrochemical capacitor that has an unusually high energy density when compared to common capacitors. They are of particular interest in automotive applications for hybrid vehicles and as supplementary storage for battery electric vehicles.

Contents

[edit] History

The first supercapacitor based on a double layer mechanism was developed in 1957 by General Electric using a porous carbon electrode (Becker, H.I., "Low voltage electrolytic capacitor", US patent 2800616 (1957-07-23)). It was believed that the energy was stored in the carbon pores and it exhibited "exceptionally high capacitance", although the mechanism was unknown at that time. It was the Standard Oil Company, Cleveland (SOHIO) in 1966 that patented a device that stored energy in the double layer interface Rightmire, R.A., "Electrical energy storage apparatus", US patent 3288641 (1966-11-29).

[edit] Current State

One of the earliest commercial-grade Electronic solutions powered by a single SuperCapacitor (a high-quality Audio mixer) was described in the milestone article "Single capacitor powers audio mixer" authored by Alexander Bell (EDN, March 14, 1997) [1]. A carefully designed circuit, which utilized micro-power amplifiers and Farad-range supercapacitor (SuperCap or DynaCap), was capable of running for more than 2 hours on a single charge. It also demonstrated the ability to be charged very fast (in about ten seconds) compared to the hours required for traditional rechargeable batteries. Due to the capacitor's high number of charge-discharge cycles (millions or more compared to 200–1000 for most commercially available rechargeable batteries) there were no disposable parts during the whole operating life of the device, which made the solution very environmentally friendly.

The idea of replacing batteries with capacitors in conjunction with novel alternative energy sources became a conceptual umbrella of Green Electricity (GEL) Initiative [2], [3], introduced by Dr. Alexander Bell. One particular successful implementation of the GEL Initiative concept was introduced in the article: “Muscle power drives battery-free electronics” (Alexander Bell, EDN, 11/21/2005)[4], describing muscle-driven autonomous, environmentally-friendly solution, which employs a multi-Farad supercapacitor (hecto- and kilofarad range capacitors are now widely available) as intermediate energy storage to power the variety of portable electrical and electronic devices such as MP3 players, AM/FM radios, flashlights, cell phones, and emergency kits. As the energy density of supercapacitors is bridging the gap with batteries, it could be expected that in the near future the automotive industry will deploy ultracapacitors as a replacement for chemical batteries.

The first trials of supercapacitors in industrial applications were carried out for supporting the energy supply to robots. [5]

In 2005 aerospace systems and controls company Diehl Luftfahrt Elektronik GmbH chose ultracapacitors Boostcap of Maxwell Technologies to power emergency actuation systems for doors and evacuation slides in passenger aircraft, including the new Airbus 380 jumbo jet. [6]

In 2006, Joel Schindall and his team at MIT began working on a "super battery", using nanotube technology to improve upon capacitors. They hope to have a prototype within the next few months and put them on the market within five years. [7]

[edit] Applications in Public Transport

China is experimenting with a new form of electric bus that runs without powerlines using power stored in large onboard supercapacitors, which are quickly recharged whenever the electric bus stops at any bus stop, and get fully charged in the terminus. A few prototypes were being tested in Shanghai in early 2005. In 2006, two commercial bus routes began to use supercapacitor buses, one of them is route 11 in Shanghai. [8]

In 2001 and 2002, VAG, the public transport operator in Nuremburg, Germany tested a bus which used a diesel-electric drive system with supercapacitors [9].

Since 2003 Mannheim Stadtbahn in Mannheim, Germany has operated an LRV (light-rail vehicle) which uses supercapacitors. [10] In this presentation [11], there is additional information about that project by the builder of the Mannheim vehicle, Bombardier Transportation, and the possible application of the technology for DMUs (Diesel Multiple Unit) trains.

Other companies from the public transport manufacturing sector are developing supercapacitor technology: The Transportation Systems division of Siemens AG is developing a mobile energy storage based on double-layer capacitors called Sibac Energy Storage [12]. The company Cegelec is also developing a supercapacitor-based energy storage system[citation needed].

[edit] Features

Such energy storage has several advantages relative to batteries:

  • Very high rates of charge and discharge.
  • Little degradation over hundreds of thousands of cycles.
  • Good reversibility
  • Low toxicity of materials used.
  • High cycle efficiency (95% or more)

Disadvantages:

  • The amount of energy stored per unit weight is considerably lower than that of an electrochemical battery (3-5 W.h/kg for an ultracapacitor compared to 30-40 W.h/kg for a battery). It is also only about 1/10,000th the volumetric energy density of gasoline.
  • The voltage varies with the energy stored. To effectively store and recover energy requires sophisticated electronic control and switching equipment.
  • Has the highest dielectric absorption of all types of capacitors.
Ragone plot showing energy density vs. power density for various energy-storage devices
Ragone plot showing energy density vs. power density for various energy-storage devices
Comparison of construction diagrams of three capacitors. Left: "normal" capacitor, middle: electrolytic, right: supercapacitor
Comparison of construction diagrams of three capacitors. Left: "normal" capacitor, middle: electrolytic, right: supercapacitor

[edit] Technology

Carbon nanotubes and certain conductive polymers, or carbon aerogels, are practical for supercapacitors. Carbon nanotubes have excellent nanoporosity properties, allowing tiny spaces for the polymer to sit in the tube and act as a dielectric. Some polymers (eg. polyacenes) have a redox (reduction-oxidation) storage mechanism along with a high surface area. MIT's Laboratory of Electromagnetic and Electronic Systems (LEES) is researching using carbon nanotubes[1].

Supercapacitors are also being made of carbon aerogel. Carbon aerogel is a unique material providing extremely high surface area of about 400-1000 m2/g. Small aerogel supercapacitors are being used as backup batteries in microelectronics, but applications for electric vehicles are expected[2].

The electrodes of aerogel supercapacitors are usually made of non-woven paper made from carbon fibers and coated with organic aerogel, which then undergoes pyrolysis. The paper is a composite material where the carbon fibers provide structural integrity and the aerogel provides the required large surface.

The capacitance of a single cell of an ultracapacitor can be as high as 3000 F (see photo at the beginning).

[edit] References

  1. ^ MIT Lees on Batteries
  2. ^ AIP

[edit] See also

[edit] External links

Wikimedia Commons has media related to:

[edit] News

Retrieved from "http://en.wikipedia.org../../../s/u/p/Supercapacitor.html"