SCOA-P wheel

From Wikipedia, the free encyclopedia

SCOA-P driving wheels

SCOA-P wheel centre detail (tyre removed)

SCOA-P pattern wheels are a type of steam locomotive wheel. Rather than having traditional solid spokes, the SCOA-P spoke is hollow, with a 'U' shaped cross section. They have a considerably lighter weight than a conventional spoked wheel or Boxpok wheel of the same size and strength.

1 History
2 Comparative performance
3 Use
4 References
5 See also

[edit] History

SCOA-P wheels were developed in the late 1940s by the Steel Company of Australia Ltd (the P in the acronym standing for F C Paynter who patented the design)^[1] in response to Victorian Railways experiencing fatigue problems with conventional spoked wheel centres. Stronger Boxpok type 'B' wheels had been installed on a number of VR locomotive classes in the late 1940s, but they had the disadvantage of being relatively heavy and also restricted maintenance access to locomotive axleboxes, underslung springs, and in some cases boiler washout plugs. Boxpok wheels were proposed for the forthcoming Victorian Railways R class 4-6-4 which had a relatively heavy 19.5 ton axle load, but it had been discovered that the use of a Boxpok wheel would make coupling rod pin removal difficult. The SCOA-P wheel was developed to allow the strength of the Boxpok design but also provide the maintenance access of a conventional spoked wheel.

[edit] Comparative performance

The SCOA-P wheel centre of a 73 inch R class driving wheel weighed only 1,829 lb, 322 lb lighter than a Boxpok design of the same diameter and equivalent strength.^[2] Load testing was conducted - using a 100 ton vertical press - of the strength and elasticity of the SCOA-P wheel centre against a 2,021 lb conventional spoked driving wheel centre of an A2 class locomotive (which shared the same diameter, but was engineered for a lower 17.5 ton axle load). The tests revealed that the lightweight SCOA-P wheel was still elastic at 23.4 tons, with a permanent set occurring at about 30 tons, whereas the heavier conventional spoked wheel experienced permanent set at 20 tons.^[2]

[edit] Use

SCOA-P driving wheels on Victorian Railways R class 4-6-4 steam locomotive R 761.

SCOA-P wheels were used on Victorian Railways' R class 4-6-4 and J class 2-8-0 locomotives, which were introduced in 1951 and 1954 respectively. They were also used on the Queensland Railways BB18¼ class 4-6-2 and Tasmanian Government Railways M class 4-6-2 and H class 4-8-2.^[3]

Because the Vulcan Foundry (which built the VR J class) continued to build SCOA-P wheeled locomotives for export until ceasing steam locomotive production in 1956, this wheel type was also seen in many of Vulcan's other export markets.

As such, SCOA-P wheel centres were found on locomotives for the Gold Coast Railway in Africa (WM and YL classes), East African Railways (30^[4] and 31^[5] classes), Iran Railways' 2-10-2 Decapod,^[6] and a class of Indian Government Railways' 2-8-4T tank locomotives,^[7] among others.