Reflectional receiver
From Wikipedia, the free encyclopedia
A Reflectional radio receiver (also called a reflex radio) is a radio receiver design in which the same amplifier is used for both the high-frequency radio (RF) and low-frequency sound (AF) signals. The radio signal from the output of the amplifier passes detection and then re-enters the input of the amplifier. During the second pass, the sound frequency is amplified then passed to the earphone.
The output of the amplifier is usually terminated by the radio frequency transformer. The amplified radio signal is taken from the secondary winding of this transformer, passes detection (by a diode in the given example) and then enters the same amplifier again as the low frequency signal. The transformer (and the antenna winding L2 in the example) have little effect on the sound frequency signal, allowing it to pass through the amplifier to the earphone.
Reflectional radio receivers are smaller and contain fewer elements. They also consume less electricity than a receiver designed with two separate amplifiers. The receiver in the schematic to the right consumes about 1 mA of current from a 1.25 V cell. However, this design is less stable, with the possibility of breaking into unwanted oscillation. A greater level of skill and experience is needed to debug the assembled device before it starts working. In the schematic to the right, the value of the resistor R1 must be carefully chosen by hand because of variations in current gain between transistors of the same part number.
For a reflex circuit to work properly, bypassing and filtering are major considerations; also, it is important to insure the signal is AT ALL TIMES entirely operating within the linear range of the amplifier, else intermod will occur. Most people do not realize when minor amounts of non liniarity occur in an amplifier. A reflex circuit will immediately produce severe distortion and possible oscillation as soon as the signal exceeds the linear range of the active component's curves, as this is the circumstance where the active device begins to work as a detector, which means it is mixing signal with the AF being fed back to amplify. This adds considerable difficulty to the making of a circuit which is dependably free of problems for all signals available. Problems are most common with large signals. LAYOUT considerations are critical in order to avoid unwanted coupling of RF signal back to the input; chokes should be toroid, not linear in physical construction, to avoid magnetic coupling for instance, and capacitive coupling must be prevented with careful layout, possibly including interleaving ground leads on PC board layout, or by using shielded wiring for hand wired circuits. However, if done properly, a reflex receiver can astound with its sensitivity and gain with minimal component count. One example on the web gives drives a speaker with enough volume level for comfortable listening with ONE transistor. The experimenter does well to try such a circuit, which is very under represented in modern experimental electronics literature.
