Methyl tert-butyl ether
From Wikipedia, the free encyclopedia
Methyl tert-butyl ether | |
---|---|
Chemical name | 2-Methoxy-2-methylpropane |
Other names | Methyl tert-butyl ether Methyl t-butyl ether MTBE tBME |
Chemical formula | C5H12O |
Molecular mass | 88.15 g/mol |
CAS number | [1634-04-4] |
Density | 0.7404 g/cm³ |
Melting point | −109 °C |
Boiling point | 55.2 °C |
Flash Point | -10 °C |
Refractive index | 1.369 |
SMILES | CC(C)(C)OC |
NFPA 704 | |
Disclaimer and references |
Methyl tert-butyl ether (MTBE) is a chemical compound with molecular formula C5H12O. MTBE is a volatile, flammable and colorless liquid that is relatively soluble in water. MTBE has a typical odour reminiscent of diethyl ether, leading to unpleasant taste and odour in water. MTBE is used in organic chemistry as a cheap solvent with properties comparable to diethyl ether but with a higher boiling point and lower solubility in water. It is also used medically to dissolve gallstones.
Contents |
[edit] Production
MTBE is manufactured by the chemical reaction of methanol and isobutylene. It was produced in very large quantities (more than 200,000 barrels per day in the United States in 1999) when it was being used widely as a fuel additive. Because of widespread releases of MTBE-containing gasoline from Underground Storage Tanks all over the US, various jurisdictions banned the use of MTBE and production was reduced. MTBE contamination in drinking water aquifers is a serious concern in many states (most famous cases are Lake Tahoe and Santa Monica). By late 2006, most American gasoline retailers had ceased using MTBE as an oxygenate, and accordingly, domestic production had declined.
[edit] Physical properties
MTBE forms azeotropes with water (52.6 °C) and methanol (51.3 °C).
[edit] Uses
MTBE is almost exclusively used as a fuel component in motor gasoline. It is one of a group of chemicals commonly known as oxygenates because they raise the oxygen content of gasoline.
[edit] As anti-knocking agent
In the US it has been used in gasoline at low levels since 1979 to replace tetra-ethyl lead to increase its octane rating and help prevent engine knocking. Oxygen helps gasoline burn more completely, reducing tailpipe emissions from pre-1984 motor vehicles. In more modern vehicles, the emissions reduction is negligible. In one respect, the oxygen dilutes or displaces gasoline components such as aromatics (e.g. benzene) and sulfur. In another, oxygen optimizes the oxidation during combustion. Most refiners have chosen to use MTBE over other oxygenates primarily for its blending characteristics and for economic reasons. It is produced from natural gas, which is cheaper than oil.
Since 1992, MTBE has been used at higher concentrations in some gasoline to fulfill the oxygenate requirements set by Congress in Clean Air Act amendments; however, since 1999, in California and other locations MTBE has begun to be phased out because of groundwater contamination (California Air Resources Board, 2004), citing unproven health effects. Due to its higher solubility in water MTBE moves more quickly than other fuel components (California Air Resources Board, 2004). The Energy Policy Act of 2005 drops the federal requirement for oxygen content in reformulated gasoline[1].
In 1995 high levels of MTBE were unexpectedly discovered in the water wells of Santa Monica, California, and the U.S. Geological Survey reported detections.[2] Subsequent U.S. findings indicate tens of thousands of contaminated sites in water wells distributed across the country. As per toxicity alone, MTBE is not classified as a hazard for the environment. The maximum contaminant level of MTBE in drinking water has not yet been established by the EPA. The leakage problem is partially attributed to the lack of effective regulations for underground storage tanks, but spillage from overfilling remains an important upset scenario. The MTBE concentrations used in the EU (usually 1.0–1.6%) and allowed (maximum 5%) in Europe are lower than in California.[3]
[edit] Alternatives
Other compounds are available as oxygenate additives for gasoline, for example ethanol and related ethers, e.g. tert-amyl methyl ether (TAME). Reasons for using MTBE include economical considerations, as some of the production is obtained by adding methanol to isobutylene produced as a by-product of other processes. However, most MTBE facilities have to manufacture the methanol and isobutylene required to produce MTBE.
Ethanol has been advertised as a safe alternative by the agricultural interest groups in the USA and Europe. Its lack of toxicity is not different from MTBE, but as a polar solvent, it drives off nonpolar hydrocarbons from the gasoline, a problem that MTBE does not cause. Volatile hydrocarbons from gasoline are known (and severe) carcinogens and the main contributor to photochemical smog. EU's agricultural subsidies have produced an oversupply of wine, and the excess low-quality wine is being refined to ethanol fuel in Europe. This gives rise to political motives for supporting ethanol over MTBE. However, the political stability of the supply is a major advantage for ethanol and other biofuels.
Advocates of both sides of the debate in the United States sometimes claim that gasoline manufacturers have been forced to add MTBE to gasoline by law. It might be more correct to say they have been induced to do so, although any oxygenate would fulfill the law.
In 2003, California was the first state to start replacing the MTBE with ethanol. Several other states started switching soon afterward.
Higher quality gasoline is also an alternative, i.e. so that additives such as MTBE are unnecessary. Iso-octane itself is used. MTBE plants can be retrofitted to produce iso-octane from isobutylene, which is a lighter-than-gasoline hydrocarbon and thus more difficult to sell.[4],[5] Iso-octane is the ideal gasoline, being the standard reference for the octane rating.
In the long run, diesel fuel is also an alternative, although it requires a major switchover to diesel-run cars. There are several varieties of biodiesel; both oxygen-containing methyl ethers and no-oxygen alkyl biodiesels are available.
[edit] In chemistry
Being an ether, MTBE is a Lewis base. However, unlike other ethers such as diethyl ether or THF, it does not coordinate well enough with magnesium to be used for making Grignard reagents. The tert-butyl group is easily cleaved off under strongly acidic conditions (forming a moderately stable carbocation), particularly if heated (isobutylene is lost), something which can limit the use of MTBE as a solvent. However it possesses one distinct advantage over most ethers- it has a much lower tendency to form explosive organic peroxides than most ethers. Opened bottles of diethyl ether or THF can build up dangerous levels of these peroxides in months, whereas samples of MTBE are usually safe for years (but they should still be tested periodically).
[edit] Persistence and pervasiveness in the environment
MTBE has widespread occurrences in the aquifers of North America, where the majority of groundwater chemistry data has been acquired. As one regional example the San Francisco Bay Area Regional Water Quality Control Board has indicated MTBE is one of the groundwater pollutants of most widespread concern in this major metropolitan region of the USA.[6]
[edit] Health risks
The IARC, a cancer research agency of the World Health Organization, maintains MTBE is not classifiable as a human carcinogen. However, exposure to high levels of MTBE has significant non-cancer-related health risks. Although the extent of MTBE as a health risk is debatable, a transparent disadvantage is that MTBE ruins the taste of water even at low concentrations of 5–15 mg/liter. As a result, significant concentrations of MTBE in drinking water are immediately detectable.
MTBE is not classified as a human carcinogen in low exposure levels by the International Agency for Research on Cancer (IARC).[7] However, it has been shown to cause kidney lesions in animals. As an ether, MTBE acts as an emulsifier, increasing the solubility of other, harmful components of gasoline (for example, the known carcinogen benzene). It thus may increase the risk of contamination by other compounds. MTBE is biodegraded very slowly, remaining in water for decades or more. In addition some MTBE degrades in blood to the associated alcohol, tert-butanol, with a greatly increased residence time. The prolonged presence of this alcohol derivative is not fully understood.
Industry advocates of MTBE contend that it has little effect on humans, although its manufacturers did not test it for its effects on human health before introducing it as an additive. As of today, researchers have limited data about the health effects from ingestion of MTBE. The Environmental Protection Agency (EPA) has concluded that available data are not adequate to quantify health risks of MTBE at low exposure levels in drinking water, but that the data support the conclusion that MTBE is a potential human carcinogen at high doses.[8]
MTBE often ends up in drinking water, e.g. when fuel storage tanks leak near water supply wells. Aside from health risks, MTBE negatively affects the taste and odor of drinking water, even at very low concentrations.
[edit] Legislation and litigation
[edit] United States
Estimates of the cost of removing MTBE from groundwater and soil contamination range from $1[9] to $30 [10]billion, including removing the compound from aquifers and municipal water supplies and replacing leaky underground oil tanks. Some controversy centers on who will pay the costs of this remediation. In one case, the cost to oil companies to clean-up the MTBE in wells belonging to Santa Monica is estimated to exceed $200 million.[11]
Recent state laws have been passed to ban MTBE in certain areas. California and New York, which together accounted for 40% of U.S. MTBE consumption, banned the chemical starting January 1, 2004, and as of September, 2005, twenty-five states had signed legislation banning MTBE. (A table of state by state information, as of 2002, is available at the United States Department of Energy website.[12]
In 2000, the U.S. EPA drafted plans to phase out the use of MTBE nationwide over four years. Upon taking office, the Bush administration cancelled those plans.
In April of 2002, a California jury found several oil companies guilty of irresponsibly manufacturing and distributing MTBE, stating that the companies acted with malice in failing to warn customers about the dangers of MTBE contamination. As of fall 2006, hundreds of other lawsuits are still pending regarding MTBE contamination of public and private drinking water supplies. Most of these lawsuits have been consolidated into "multi-district litigation" before Judge Shira A. Scheindlin in the federal district court for the Southern District of New York.
The Energy Policy Act of 2005, passed in the House on April 21, 2005, did not include a provision for shielding MTBE manufacturers from water contamination lawsuits. This provision was first proposed in 2003 and had been thought by some to be a priority of Tom DeLay and Rep. Joe Barton, chairman of the Energy and Commerce Committee.[13] This bill also includes a provision that gives MTBE makers, including some major oil companies, $2 billion in transition assistance as MTBE is phased out over the next nine years.[14] Due to opposition in the Senate, the conference report dropped all MTBE provisions. The final bill was passed by both houses and signed into law by President Bush.[15] The lack of MTBE liability protection is resulting in a switchover to the use of ethanol as a gasoline additive, which is in limited supply in April 2006. Some traders and consumer advocates are blaming this for an increase in gasoline prices.[16]
Certain patents important in the manufacture of MTBE are not held by American companies; for example, United States patent 5536886, Process for preparing alkyl ethers,[17] is owned by the Finnish company Neste. The same corporation also went on to patent the replacement of the MTBE process, an octane production process trademarked NExOCTANE.
The United States Environmental Protection Agency (EPA) currently lists methyl tertiary butyl ether (MTBE) as a candidate for a maximum contaminant level (MCL) in drinking water[18]. MCL's are determined by the EPA using toxicity data. Currently, only organoleptic drinking water standards are enforced by the EPA.
[edit] References
- ^ http://www.epa.gov/otaq/rfg regs.htm#usage
- ^ U.S. Geological Survay detections
- ^ European Commission. MTBE and the Requirements for Underground Storage Tank Construction and Operation in Member States.
- ^ http://www.nesteengineering.com/default.asp?path=111,360,362,477
- ^ http://www.halliburton.com/kbr/hydroChem/petroChem/nexoctane.jsp
- ^ San Francisco Bay Area Regional Water Quality Control Board Integrated Basin Management Plan (2004)
- ^ http://monographs.iarc.fr/ENG/Monographs/vol73/volume73.pdf
- ^ http://www.epa.gov/mtbe/faq.htm#concerns
- ^ [1]
- ^ [2]
- ^ [3]
- ^ Website U.S. Department of Energy
- ^ http://www.cnn.com/2005/POLITICS/04/21/energy.bill.mtbe.ap/
- ^ http://www.msnbc.msn.com/id/7574562/+MTBE&hl=en
- ^ http://thomas.loc.gov/cgi-bin/bdquery/z?d109:h.r.00006:
- ^ prices ethanol/index.htm?cnn=yes http://money.cnn.com/2006/04/18/news/economy/gas prices ethanol/index.htm?cnn=yes
- ^ http://www.freepatentsonline.com/5536886.html
- ^ CCL 2 List