Gas in a box
From Wikipedia, the free encyclopedia
In quantum mechanics, the results of the quantum particle in a box can be used to look at the equilibrium situation for a quantum ideal gas in a box which is a box containing a large number of monocles which do not interact with each other except for instantaneous thermalizing collisions. This simple model can be used to describe the classical ideal gas as well as the various quantum ideal gases such as the ideal massive Fermi gas, the ideal massive Bose gas as well as black body radiation which may be treated as a massless Bose gas.
Using the results from either Maxwell-Boltzmann statistics, Bose-Einstein statistics or Fermi-Dirac statistics we use the Thomas-Fermi approximation and go to the limit of a very large box, and express the degeneracy of the energy states as a differential, and summations over states as integrals. We will then be in a position to calculate the thermodynamic properties of the gas using the partition function or the grand partition function. These results will be carried out for both massive and massless particles. More complete calculations will be left to separate articles, but some simple examples will be given in this article.
Contents |
[edit] Thomas-Fermi approximation for the degeneracy of states
For both massive and massless particles in a box, the states of a particle are enumerated by a set of quantum numbers. [nx, ny, nz]. The absolute value of the momentum is given by:
where h is Planck's constant and L is the length of a side of the box. We can think of each possible state of a particle as a point on a 3-dimensional grid of positive integers. The distance from the origin to any point will be
Suppose each set of quantum numbers specify f states where f is the number of internal degrees of freedom of the particle that can be altered by collision. For example, a spin 1/2 particle would have f=2, one for each spin state. The Thomas-Fermi approximation assumes that the quantum numbers are so large that they may be considered to be a continuum. For large values of n , we can estimate the number of states with absolute value of momentum less than or equal to p from the above equation as
which is just f times the volume of a sphere of radius n divided by eight since we only consider the octant with positive ni . The number of states with absolute value of momentum between p and p+dp is therefore
where V=L3 is the volume of the box. Notice that in using this continuum approximation, we have lost the ability to characterize the low-energy states including the ground state where ni =1. For most cases this will not be a problem, but when considering Bose-Einstein condensation, in which a large portion of the gas is in or near the ground state, we will need to recover the ability to deal with low energy states.
Without using the continuum approximation, the number of particles with energy εi is given by
where
-
for particles obeying Maxwell-Boltzmann statistics for particles obeying Bose-Einstein statistics for particles obeying Fermi-Dirac statistics
with β = 1/kT with k being Boltzmann's constant, T being temperature, and μ being the chemical potential. Using the continuum approximation, the number of particles dN with energy between E and E+dE is now written:
[edit] The energy distribution function
We are now in a position to determine some distribution functions for the "gas in a box". The distribution function for any variable A is PAdA and is equal to the fraction of particles which have values for A between A and A+dA
It follows that:
The distribution function for the absolute value of the momentum is:
and the distribution function for the energy E is:
For a particle in a box (and for a free particle as well), the relationship between energy E and momentum p is different for massive and massless particles. For massive particles, we have
while for massless particles:
where m is the mass of the particle and c is the speed of light. Using these relationships we have:
- For massive particles
- For massless particles
[edit] Specific examples
The following sections give an example of results for some specific cases.
[edit] Massive Maxwell-Boltzmann particles
For this case:
Integrating the energy distribution function and solving for N gives
Substituting into the original energy distribution function gives
which are the same results obtained classically for the Maxwell-Boltzmann distribution. Further results can be found in the article on the classical ideal gas.
[edit] Massive Bose-Einstein particles
For this case:
where z is defined as
Integrating the energy distribution function and solving for N gives the particle number
Where Lis(z) is the polylogarithm function and Λ is the thermal wavelength. The polylogarithm term must always be positive and real, which means its value will go from 0 to ζ(3/2) as z goes from 0 to 1. As the temperature drops towards zero, Λ will become larger and larger, until finally Λ will reach a critical value Λc where z=1 and
The temperature at which Λ=Λc is the critical temperature. For temperatures below this critical temperature, the above equation for the particle number has no solution. The critical temperature is the temperature at which a Bose-Einstein condensate begins to form. The problem is, as mentioned above, that the ground state has been ignored in the continuum approximation. It turns out, however, that the above equation for particle number expresses the number of bosons in excited states rather well, and so we may write:
where the added term is the number of particles in the ground state. (The ground state energy has been ignored.) This equation will hold down to zero temperature. Further results can be found in the article on the ideal Bose gas.
[edit] Massless Bose-Einstein particles (e.g. black body radiation)
For the case of massless particles, we must now use the massless energy distribution function. It is convenient to convert this function to a frequency distribution function:
where Λ is the thermal wavelength for massless particles. The spectral energy density (energy per unit volume per unit frequency) is then
Other thermodynamic parameters may be derived analogously to the case for massive particles. For example, integrating the frequency distribution function and solving for N gives the number of particles:
The most common massless Bose gas is a photon gas in a black body. Taking the "box" to be a black body cavity, the photons are continually being absorbed and re-emitted by the walls. When this is the case, the number of photons is not conserved. In the derivation of Bose-Einstein statistics, when the restraint on the number of particles is removed, this is effectively the same as setting the chemical potential (μ) to zero. Furthermore, since photons have two spin states, we have f=2. The spectral energy density is then
which is just the spectral energy density for Planck's law of black body radiation. Note that if we had carried out this procedure for massless Maxwell-Boltzmann particles, we would recover Wien's distribution which approximates a Planck's distribution for high temperature or low density.
In certain situations, the reactions involving photons will result in the conservation of the number of photons (e.g. light-emitting diodes, "white" cavities). In these cases, the photon distribution function will involve a non-zero chemical potential. (Hermann 2005)
Another massless Bose gas is given by the Debye model for heat capacity. This considers a gas of phonons in a box and differs from the development for photons in that the speed of the phonons is less than light speed, and there is a maximum allowed wavelength for each axis of the box. This means that the integration over phase space cannot be carried out to infinity, and instead of results being expressed in polylogarithms, they are expressed in the related Debye functions.
[edit] Massive Fermi-Dirac particles (e.g. electrons in a metal)
For this case:
Integrating the energy distribution function gives
Where again, Lis(z) is the polylogarithm function and Λ is the thermal de Broglie wavelength. Further results can be found in the article on the ideal Fermi gas.
[edit] References
- Herrmann, F.; Würfel, P. (August 2005). "Light with nonzero chemical potential" (PDF). American Journal of Physics 73 (8): 717-723. DOI:10.1119/1.1904623#. Retrieved on 2006-11-20.
- Huang, Kerson (1967). Statistical Mechanics. New York: John Wiley & Sons.
- Isihara, A. (1971). Statistical Physics. New York: Academic Press.
- Landau, L. D.; E. M. Lifshitz (1996). Statistical Physics, 3rd Edition Part 1, Oxford: Butterworth-Heinemann.
- Yan, Zijun (2000). "General thermal wavelength and its applications" (PDF). Eur. J. Phys. 21: 625-631. DOI:10.1088/0143-0807/21/6/314. Retrieved on 2006-11-20.