Direct-sequence spread spectrum
From Wikipedia, the free encyclopedia
In telecommunications, direct-sequence spread spectrum (DSSS) is a modulation technique. As with other spread-spectrum technologies, the transmitted signal takes up more bandwidth than the information signal that is being modulated. The name 'spread spectrum' comes from the fact that the carrier signals occur over the full bandwidth (spectrum) of a device's transmitting frequency.
Contents |
[edit] Features
- It phase-modulates a sine wave pseudorandomly with a continuous string of pseudonoise code symbols called "chips", each of which has a much shorter duration than an information bit. That is, each information bit is modulated by a sequence of much faster chips. Therefore, the chip rate is much higher than the information signal bit rate.
- It uses a signal structure in which the sequence of chips produced by the transmitter is known a priori by the receiver. The receiver can then use the same PN sequence to counteract the effect of the PN sequence on the received signal in order to reconstruct the information signal.
[edit] Transmission method
Direct-sequence spread-spectrum transmissions multiply the data being transmitted by a "noise" signal. This noise signal is a pseudorandom sequence of 1 and −1 values, at a frequency much higher than that of the original signal, thereby spreading the energy of the original signal into a much wider band.
The resulting signal resembles white noise, like an audio recording of "static", except that this noise can be filtered out at the receiving end to recover the original data, by again multiplying the same pseudorandom sequence to the received signal (because 1 × 1 = 1, and −1 × −1 = 1). This process, known as "de-spreading", mathematically constitutes a correlation of the transmitted PN sequence with the receiver's assumed sequence.
For de-spreading to work correctly, the transmit and receive sequences must be synchronized. This requires the receiver to synchronize its sequence with the transmitter's sequence via some sort of timing search process. However, this apparent drawback can be a significant benefit: if the sequences of multiple transmitters are synchronized with each other, the relative synchronizations the receiver must make between them can be used to determine relative timing, which, in turn, can be used to calculate the receiver's position if the transmitters' positions are known. This is the basis for many satellite navigation systems.
The resulting effect of enhancing signal to noise ratio on the channel is called processing gain. This effect can be made larger by employing a longer PN sequence and more chips per bit, but physical devices used to generate the PN sequence impose practical limits on attainable processing gain.
If an undesired transmitter transmits on the same channel but with a different PN sequence (or no sequence at all), the de-spreading process results in no processing gain for that signal. This effect is the basis for the code division multiple access (CDMA) property of DSSS, which allows multiple transmitters to share the same channel within the limits of the cross-correlation properties of their PN sequences.
As this description suggests, a plot of the transmitted waveform has a roughly bell-shaped envelope centered on the carrier frequency, just like a normal AM transmission, except that the added noise causes the distribution to be much wider than that of an AM transmission.
In contrast, frequency-hopping spread spectrum pseudo-randomly re-tunes the carrier, instead of adding pseudo-random noise to the data, which results in a uniform frequency distribution whose width is determined by the output range of the pseudo-random number generator.
[edit] Benefits
- Resistance to intended or unintended jamming.
- Sharing of a single channel among multiple users.
- Determination of relative timing between transmitter and receiver.
[edit] Uses
- The United States GPS, Russian Glonass, and European Galileo satellite navigation systems.
- CDMA cellular phones.
- Cordless phones operating in the 2.4 and 5.8 GHz bands.
- The 802.11 and 802.11b Wi-Fi standards. (The faster modes in 802.11g use OFDM, not spread spectrum, although it can fall back to the slower 802.11b modes.)
- ZigBee / 802.15.4
