Digital Control Bus

From Wikipedia, the free encyclopedia

Digital Control Bus or DCB was a proprietary data interchange interface by Roland Corporation, introduced in the Roland Juno-60 and Roland Jupiter-8 in 1982. DCB functions were basically the same as MIDI, but unlike MIDI, which is capable of transmitting a wide array of information, DCB could provide note on/off and program change only. Data was relayed using a thick cable that connected to a port vaguely resembling a parallel port on a computer. DCB to MIDI adapters were produced for a number of early Roland products. The DCB interface was made in 2 variants, using 15-pin and 20-pin sockets and cables.

[edit] Supporting equipment

DCB did not exist for long and was replaced by MIDI in the early 1980s. The only DCB-equipped instruments produced were the Roland Jupiter-8 and Juno-60. Roland produced at least two DCB sequencers, the JSQ-60 and the MSQ-700.

The latter was capable of saving eight sequences or a total of 3000 notes and was also capable of transmitting and receiving data via MIDI. (It could not convert signals betwwen DCB and MIDI, nor could it use both protocols simultaneously). Roland later released the MD-8, a rather large black box capable of converting MIDI signals to DCB and vice versa. While this allows note on/off to be sent to a Juno-60 by MIDI, the solution pales in comparison to the full MIDI implementation on the Juno-60's successor, the Roland Juno-106.

Nowadays, a few companies offer similar conversion boxes to connect DCB instruments to regular MIDI systems for support of vintage synths in modern sound production environments.