Diaphragm compressor
From Wikipedia, the free encyclopedia
A diaphragm compressor is a variant of the classic reciprocating compressor with backup and piston rings and rod seal. The compression of gas occurs by means of a flexible membrane, instead of an intake element. The back and forth moving membrane is driven by a rod and a crankshaft mechanism. Only the membrane and the compressor box come in touch with pumped gas. For this reason this construction is the best suited for pumping toxic and explosive gases. The membrane has to be reliable enough to take the strain of pumped gas. It must also have adequate chemical properties and sufficient temperature resistance.
A diaphragm compressor is the same as a membrane compressor.
[edit] Compression of hydrogen gas with a diaphragm compressor
The photograph included in this section depicts a three-stage diaphragm compressor used to compress hydrogen gas to 6,000 psi (41 MPa) for use in a prototype hydrogen and compressed natural gas (CNG) fueling station built in downtown Phoenix, Arizona by the Arizona Public Service company (an electric utilities company). Reciprocating compressors were used to compress the natural gas.[1]
The prototype alternative fueling station was built in compliance with all of the prevailing safety, environmental and building codes in Phoenix to demonstrate that such fueling stations could be built in urban areas.[1]
[edit] See also
[edit] References
- ^ a b Alternative Fuel (Hydrogen) Pilot Plant Design Report (Report INEEL / EXT-O3-00976 of the Idaho National Laboratory of the U.S. Department of Energy)
