Blowout (well drilling)

From Wikipedia, the free encyclopedia

This article or section uses abbreviations that may be confusing or ambiguous.
To meet Wikipedia's quality standards and be more accessible to a general audience, this article or section may require cleanup.
Please improve the article or discuss changes on the talk page. (help)

A blowout is the uncontrolled release of a formation fluid, usually gas, from a well being drilled, typically for petroleum production. A blowout is caused when a combination of well control systems fail—primarily drilling mud hydrostatics and blow-out preventers (BOPs)—and formation pore pressure is greater than the wellbore pressure at depth. When such an incident occurs, formation fluids begin to flow into the wellbore and up the annulus and/or inside the drill pipe, and is commonly called a kick. If the well is not shut in, a kick can quickly escalate into a blowout when the formation fluids reach the surface, especially when the fluid is a gas, which rapidly expands as it flow up the wellbore and accelerates to near supersonic speeds. Blowouts can cause significant damage to drilling rigs, and injuries or fatalities to rig personnel.

1 Formation kick
- 1.1 Blowout
- 1.2 A Blowout on a Land Rig
2 See also

[edit] Formation kick

A kick can be the result of improper mud density control, an unexpected overpressured gas pocket, or may be a result of the loss of drilling fluids to a formation called a thief zone. If the well is a development well (and not a wildcat), these thief zones should already be known to the driller and the proper loss control materials would be used. However, unexpected fluid losses can occur if a formation is fractured at the depth of the drill bit, causing rapid loss of hydrostatic pressure and flow of formation fluids from a shallower formation into the wellbore. Overpressured gas pockets are generally unpredictable and usually cause the more violent blowouts.

The primary means of detecting a kick is the loss of circulation back up to the surface into the mud pits. The mud engineer keeps track of the level in the mud pits, and a drop in this level would indicate lost circulation to a formation. The rate of mud returns is also closely monitored to match the rate that it is being pumped downhole. If the rate of returns is slower than expected, then a certain amount of the mud is being lost to a thief zone. In the case of the overpressured gas pocket, an increase in mud returns would be noticed when the formation gasses push the drilling mud to the surface at a rapid rate.

The first response to detecting a kick would be to isolate the well from the surface by activing the BOPs. Once the wellbore is isolated, the drilling crew would attempt to circulate in a kill fluid (usually with the assistance of a well control company) to bring hydrostatic pressure back up to proper levels, compress the kick gasses, and slowly circulate out the gas in a controlled manner, taking care not to allow the gas to accelerate up the wellbore.

Often, however, companies drill underbalanced for better, faster penetration rates and thus they "drill for kicks" as it is economically sounder to take time to kill a kick than to drill overbalanced (slow penetration rates). Under these circumstances calling in a "well control" specialist is not necessary.

[edit] Blowout

When all the controls described above fail, a blowout occurs. Blowouts are dangerous since they can eject the drill string out of the well, and the force of the escaping fluid can be strong enough to damage the drilling rig. Blowouts usually ignite due to the presence of an ignition source or simply due to heat generated by the friction of the gasses. A well control company will then need to extinguish the well fire, cap the well, and replace the casing head and hangars.

Sometimes, blowouts can be so forceful that they cannot be directly extinguished, particularly if there is so much energy in the gas zone that it does not deplete significantly over the course of a blowout. In such cases, other wells may be drilled to intersect the well or pocket at some depth, in order to help relieve pressure using multiple outlets from the gas zone.