ANOVA Gage R&R

From Wikipedia, the free encyclopedia

You have new messages (last change).

ANOVA Gage R&R (or ANOVA Gage Repeatability & Reproducibility) is a Measurement Systems Analysis technique which uses Analysis of Variance (ANOVA) to assess a measurement system.

[edit] Purpose

ANOVA Gage R&R measures the amount of variability induced in measurements that comes from the measurement system itself and compares it to the total variability observed to determine the viability of the measurement system. There are four components affecting a measurement system:

  • Measurement devices (machine), the gage itself and all mounting blocks, supports, fixtures, load cells etc. The machine ease of use, sloppiness among mating parts, "zero" blocks are examples of sources of variation in the measurement system;
  • Operators (people), the ability and/or discipline of a person to follow the written or verbal instructions.
  • Measurement instructions (method), how to setup your devices, how to mount your parts, how to record the data, etc.
  • Specification, the measurement is reported against a specification or a reference value. The range of the specification does not affect the measurement, but is an important factor affecting the viability of the measurement system.
  • Parts (what is being measured), some parts are easier to measure than others. A measurement system may be good for measuring block length but not for measuring rubber pieces.

There are two important aspects on a Gage R&R:

  • Repeatability, the ability of the device to provide consistent results. It is a measure of the variabilty induced by the system if the same operator measured the same part using the same device repeatedly.
  • Reproducibility, the variability induced by the operators. It is the variation induced when different operators measure the same part using the same device.

It is important to understand the difference between Accuracy and precision in order to understand the purpose of Gage R&R. Gage R&R only address how precise an measurement system is.

Anova Gage R&R is an important tool within the Six Sigma methodology, and is also a requirement for PPAP documentation.

[edit] Common Misconceptions about GRR

  • Need only one GRR per family of gages. It is usual to say "There is an acceptable GRR for this caliper". The GRR is for the measurement system, which includes the part, the specification, the operator and the method. Measuring a steel block with a caliper may give a good precision, but the same caliper may not be suitable to measure soft rubber parts that may deform while it is being measured.
  • The GRR will not pass using parts, so it has to be done with standard weights and blocks. The GRR done on this way will assess the precision while measuring standard weights. The device might not be suitable to measure that specific type of parts.
  • Need to report on PPAP documentation GRR results for everything that is measured. This is not necessarily a requirement. The Quality Engineer usually uses an educated assessment. If the characteristic is critical to safety, a valid GRR is required. Instead, if there is enough understanding that some particular part is easy to measure with acceptable precision, a formal GRR is not required. Custumers may ask for additional GRRs upon PPAP reviews.
  • Performing a GRR is very expensive. In order to perform a GRR usually a number of parts (sometimes between 5 to 10) is required to be measured by 2 to 3 operators 2 to 3 times. So the measurement costs are the ones associated with those additional measurements. For simple devices this may not be very costly, and the results is a known measurement error that can be used to assess all measurements subsequent to that.

[edit] External References

Retrieved from "http://en.wikipedia.org../../../a/n/o/ANOVA_Gage_R%26R_86e6.html"