Tung oil
From Wikipedia, the free encyclopedia
Tung oil is used as a wood finishing product. It has two distinct meanings, pure tung oil and tung oil finishes, which are often confused.
Contents |
[edit] Pure tung oil
Tung oil is made from the pressed seed from the nut of the tung tree. Tung oil is considered a drying oil much as linseed, safflower, poppy and soybean oil. When applied it provides a tough, highly water resistant finish which does not darken noticeably with age as does linseed oil.
Tung oil is also sometimes called “China wood oil”. It has been used for hundreds if not thousands of years in China to seal decorative and marine wood as well as porous masonry.
[edit] Polymerized tung oil
Pure Tung oil, heated or chemically treated will substantially increase the viscosity and film-forming quality of the product. The resulting oil will range in consistency from that of maple syrup to that of a motor oil. Unlike the raw product, it may be applied in thick layers and will result in a coating with substantial gloss and extraordinary durability.
[edit] “Tung oil” finishes
“Tung oil finish” refers to a wetted wood look that a succession of penetrating tung oil applications gives. However, it is also a generic term and has been liberally borrowed by paint-and-varnish makers to describe the expected result of using their preparations — which may or may not actually contain any tung oil at all.
[edit] Application
The traditional technique is to apply the diluted oil as a succession of very thin films with soft non-fuzzy cloth like tee-shirt cotton. Dilutants range from traditional Spirits of turpentine to any of the new citrus thinners to VM&P naphtha. The choice of thinner should be guided by how fast the coating needs to set. Naphtha is often too fast, but works well in spray-on applications in well ventillated studios. Primary coats may be laid down at a 1:2 oil-to-thinner ratio, and successive layers (3 or more) at higher oil concentrations, with the final layer consisting of the oil alone. This technique results in the traditional wet-wood look by filling in all open wood cells as water does. The finish is matte by its nature.
Tung oil finishes that start with polymerized pure oils or ‘tung oil preparations’ are best applied in the fat over lean principle: thinned pure oil is applied to deeply penetrate the surface, to fill pores. Straight oil is then applied moderately to adhere to the surface and provide a good base for the thick gloss layers. The polymerized oil is then applied thickly as a single layer, allowed to fully dry, is buffed smooth with very fine sandpaper then 00 steel wool. The surface is wiped clean with a moistened rag, then allowed to dry. A final coat is again applied fairly thickly — the oil will smooth itself into a glass-like coating — and allowed to dry for two to three days. The resulting finish is almost completely impervious to water.
[edit] Other uses
As the penetrating power of tung oil is excellent and able to adhere to porous minerals, it is often the “secret” ingredient that traditional stonemasons apply to granite or marble that is destined to serve duty in kitchens, bathrooms and other staining fluid environments. Applied at a 1:5 ratio (oil to naphtha), it seals the surfaces permanently, while also giving a finish like that of wet stone to the product. Often several thin layers were applied at the high solvent-to-oil ratio, in order to build up the durability and permanence of the coating. The non-yellowing nature of tung oil is vitally important for its satisfactory use in these applications. Clean up, especially of hands, may be difficult without a solvent.
