Television interference (strong signal)

From Wikipedia, the free encyclopedia

It has been suggested that this article or section be merged with Television interference. (Discuss)

Television interference (strong signal)

It is possible to also get a bad picture if the signal strength of the TV transmitter is too high, for instance in the Bromley area of south east London the signal from the TV mast is so strong that it may cause the TV's front end to be overloaded. Check for this by inserting an attenuator inside with the TV aerial connection. If you start by trying with 10 dB, and then move to 20 dB then this might provide a cure.

It is interesting to note that in that part of London the TV transmitter (Crystal Palace Transmitter) and the Croydon Transmitter tower which has VHF pager transmitters are both such strong sources of radiowaves that FM only UHF (432 MHz) and VHF (144 MHz) radiosets can become overwhelmed with they are attached to a beam aerial which is pointed at the Crystal Palace and Croydon towers respectively. It is interesting to note that the receiver of the FT-290R2 which is a 144 MHz multimode (FM/CW/SSB) radio is more able to cope with such strong out of band signals.

So this problem of overloading is not confined to TV sets only. One of the reasons these FM radio sets have this shortcoming is the fact that they often use two diodes which are wired across the front end of the front end. These two diodes act in the same way as the rusty bolt, the receiver then experiences a great array of mixing (intermodulation) products some of which fall upon the frequency which the radio is tuned to.

It is vital that before you attempt to start to locate an unwanted source of radio signals that you first check that the unwanted signal is not being generated in the front end of your radio set. By adding either an attenuator or a band pass filter to the radio its front end can be protected from these out of band signals.