SN2 reaction
From Wikipedia, the free encyclopedia
- The correct title of this article is SN2 reaction. It features superscript or subscript characters that are substituted or omitted because of technical limitations.
The SN2 reaction is a type of nucleophilic substitution, where a nucleophile attacks an electrophilic center and bonds to it, expelling another group called a leaving group. Thus the incoming group replaces the leaving group in one step. Since two reacting species are involved in the slow, rate-determining step of the reaction, this leads to the name bimolecular nucleophilic substitution, or SN2. The somewhat more transparently named analog to SN2 among inorganic chemists is the interchange mechanism.
The reaction most often occurs at an aliphatic sp3 carbon center. The breaking of the C-X bond and the formation of the new C-Nu bond occur simultaneously to form a transition state in which the carbon under nucleophilic attack is pentavalent, and approximately sp2 hybridised. The nucleophile attacks the carbon at 180° to the leaving group, since this provides the best overlap between the nucleophile's lone pair and the C-X σ* antibonding orbital. The leaving group is then pushed off the opposite side and the product is formed.
If the substrate under nucleophilic attack is chiral, this leads to an inversion of stereochemistry, called the Walden inversion.
In an example of the SN2 reaction, the attack of OH− (the nucleophile) on a bromoethane (the electrophile) results in ethanol, with bromide ejected as the leaving group.
SN2 attack occurs if the backside route of attack is not sterically hindered by substituents on the substrate. Therefore this mechanism usually occurs at an unhindered primary carbon centre. If there is steric crowding on the substrate near the leaving group, such as at a tertiary carbon centre, the substitution will involve an SN1 rather than an SN2 mechanism, (an SN1 would also be more likely in this case because a sufficiently stable carbocation intermediary could be formed.) The rate of an SN2 reaction is second order, as the rate-determining step depends on the nucleophile concentration, [Nu−] as well as the concentration of substrate, [RX].
- J = k[RX][Nu−]
This is a key difference between the SN1 and SN2 mechanisms. In the SN1 reaction the nucleophile attacks after the rate-limiting step is over, whereas in SN2 the nucleophile forces off the leaving group in the limiting step. In cases where both mechanisms are possible (for example at a secondary carbon centre), the mechanism depends on solvent, temperature, concentration of the nucleophile or on the leaving group.
SN2 reactions are generally favoured in primary alkyl halides or secondary alkyl halides with an aprotic solvent. They occur at a negligible rate in tertiary alkyl halides due to steric hindrance.
It is important to understand that SN2 and SN1 are two extremes of a sliding scale of reactions, it is possible to find many reactions which exhibit SN2 and some SN1 character in their mechanisms. For instance, it is possible to get a contact ion pairs formed from an alkyl halide in which the ions are not fully separated. When these undergo substitution the stereochemistry will be inverted (as in SN2) for many of the reacting molecules but a few may show retention of configuration.
