Lugger
From Wikipedia, the free encyclopedia
|
- For the bird of prey, see Laggar Falcon.
A lugger is a type of small sailing vessel setting lugsails on two or more masts and perhaps lug topsails. While this article is written in the present tense, in European waters at least, except as museum pieces, luggers are things of the past.
[edit] Defining the rig
The lugsail is an evolved version of the classical square sail. In both rigs, the upper side of the sail is attached to a spar, the yard, which is hoisted up the mast by a rope known as the halyard. The lower side of the sail is held in place by a separate set of ropes, the sheets.
The main difference between the lugsail and square is the location of the yard in relation to the mast. A square sail is lifted with the halyard in the middle of the yard, lifting the sail so it lies evenly on either side of the mast. In the lugger, the halyard is attached much closer to one end or the other of the yard, and when lifted the majority of the sail will lie fore or aft of the mast. Since the yard is only supported near one end, the "free" end hangs down and the "supported" end peaks up. This allows the mast to be shorter than the sail, the peaked yard making up the difference in height.
The lugsail is somewhat similar to the gaff rig as well, which also uses a spar, the gaff, which is hung at an angle to the mast. The difference is that the gaff is mounted such that it lies entirely behind the mast, as opposed to both in front and behind as in the lugger. While the gaff rig is "cleaner" in that the mast does not interfere with the sail, it requires more complex rigging and handling than the lugger.
[edit] Types of lugsail
There are three sorts of lugsail: the standing lug, in which the yard remains on one side of the mast and the tack is set close to the mast, the balanced lug, which resembles the standing lug, but in which the boom continues as far forward of the mast as the leading edge of the yard, and the dipping lug in which the yard is dipped around the mast when going about so that the sail draws away from the mast on each tack.
The advantages of the dipping sail arise from the fact that the set of the sail is not deformed by pressing against the mast. This allows a more efficient air flow and reduces wear of the canvas. Its disadvantage is that with any but a very small sail, a downhaul is needed and the size of the sail which can be manipulated in this way is limited.
When going about, the moment during which it is possible to dip the lug is short and it is not easy to coordinate the efforts of the crew. Therefore lugsails are usually standing or balanced lugs.
Another source of variation is in the extent to which the yard was designed to be peaked up. That is to say, how nearly vertical the yard was intended to be.
The accompanying picture of Fifies, (above right) a fairly late design in the evolution of the rig, shows one extreme, where the white-sailed boat looks almost to have a Bermudian rig. The boat off-shore is a little more obviously a lugger and the others have not got their sails fully set.
The fore lug (main sail) on a Fifie is a dipping lugsail. The extreme size of the dipping lugsail showing in the picture was only possible with the introduction of steam powered capstans to facilitate with dipping.
This short extract explains the procedure:
"Imagine tacking in a fresh breeze with those tremendous forelugs flogging about. First they were lowered down to deck, then unhooked from the traveller, hooked on the burton, swung aft and then for'ard on the other side of the mast, unhooked and rehooked on the traveller, and hoisted again. During this time the mast stood foursquare on its reputation. being completely unstayed until the halyards were unhooked to the weather side and the burton set up. Smart handling was essential, and even with the fall of the haylard taken to the capstan, it was heavy work, but hositing by hand was back-breaking, five to ten minutes' sweating to get the sail set and drawing properly for most of the old skippers were very particular about the cut and set of their sails." Page 266, Chapter 12 (Fifies and Zulus), Sailing Drifter by Edgar J. March
This picture of a Fifie more clearly shows the difference in the position of the tack (lower forward corner of the sail) as between a standing lug (here, the mizzen) and dipping lug (here, the main). These yards are shown set to the port sides of the masts.
[edit] Handling characteristics
The rig combines the handiness of a fore and aft rig with much of the efficiency when running, of a square rig. A bigger lugger might set lug topsails which are very much like the lower sails but less deep. Some of the Breton chasse-marées carried topgallants. The standing sail is usually set to the starboard side of the mast. It is said that the comparative disadvantage of having the sail deformed on the starboard tack was why the rule of the road gave the right of way to a sailing vessel in that condition.
Once hoisted, the set of the sail is controlled by adjustment of the tack tackle (pronounced tak taykl) and the sheet. It is therefore much simpler to use than a square sail so that the crew can be smaller or doing work other than that of sailing the vessel, such as that to do with fishing.
[edit] The name
The lugsail was the earliest of the fore and aft rigs. The origin of its name is not wholly clear. The name 'lugger' may derive from the Middle Dutch for 'to trawl' or it may take its name from the lugsail. That in turn, may have its origin in the similarity of the appearance of a human ear to a fore and aft sail. The French for a fore and aft rig is un gréement aurique or for the sail, it is une voile aurique - an ear type sail. Since 'lug' is an English word for ear, this origin is a possibility.
A popular type of recreational boat of the 20th Century was named the "Drascombe Lugger." Despite its name, the vessel was not equipped with a lugsail rig.
[edit] Local types
- Hastings lugger
- Fifie Scottish East Coast, herring drifter
- French (Normandy) lugger (lougre)
- Breton chasse-marée
- Barca-longa of Iberian and Mediterranean coasts
- Coble (not strictly a lugger as they had only one mast) On the English east coast from Yorkshire northwards.
