Hot filament ionization gauge

From Wikipedia, the free encyclopedia

Note: Principles are mostly the same for hot cathode ion sources in particle accelerators to create electrons

The hot filament ionization gauge sometimes called a hot filament and hot cathode , is the most widely used vacuum (negative pressure) measuring device for the region from 10-1 to 10-9 pascals. It is a triode, where as the filament is the cathode.

Contents

[edit] Function

A regulated electron current (typically 10 mA) is emitted from a heated filament. The electrons are attracted to the helical grid by a dc potential of about +150 volts. In their passage from the filament to the grid the electrons collide with gas molecules in the gauge envelope causing a fraction of them to be ionized. The gas ions formed by the electron collisions are attracted to the central ion collector wire by the negative voltage on the collector (typically a minus 30 volts). Ion currents are on the order of 1 mA/Pa. This current is amplified and displayed by a high gain differential amplifier/ electrometer.

This ion current will differ for different gasses at the same pressure, that is, a hot filament ionization gauge is composition-dependent. Over a wide range of molecular density , however the ion current from a gas constant composition will be directly proportional to the molecular density of the gas in the gauge.

Copied from the ionization gauge arcticle (Somehow there is too much duplication in the structure):

A hot cathode ionization gauge is mainly composed of three electrodes all acting as a triode, where the cathode is the filament. The three electrodes are a collector or plate, a filament, and a grid. The collector current is measured in picoamps by an electrometer. The filament voltage to ground is usually at a potential of 30 volts while the grid voltage at 180–210 volts DC, unless there is an optional electron bombardment feature, by heating the grid which may have a high potential of approximately 565 volts. The most common ion gauge is the hot cathode Bayard-Alpert gauge, with a small collector inside the grid. A glass envelope with an opening to the vacuum can surround the electrodes, but usually the Nude Gauge is inserted in the vacuum chamber directly, the pins being fed through a ceramic plate in the wall of the chamber. Hot cathode gauges can be damaged or lose their calibration if they are exposed to atmospheric pressure or even low vacuum while hot.

Electrons emitted from the filament move several times in back and forth movements around the grid before finally entering the grid. During these movements, some electrons collide with a gaseous molecule to form a pair of an ion and an electron (Electron ionization). The number of these ions is proportional to the gaseous molecule density multiplied by the electron current emitted from the filament, and these ions pour into the collector to form an ion current. Since the gaseous molecule density is proportional to the pressure, the pressure is estimated by measuring the ion current.

The low pressure sensitivity of hot cathode gauges is limited by the photoelectric effect. Electrons hitting the grid produce x-rays that produce photoelectric noise in the ion collector. This limits the range of older hot cathode gauges to 10-8 Torr and the Bayard-Alpert to about 10-10 Torr. Additional wires at cathode potenial in the line of sight between the ion collector and the grid prevent this effect. In the extraction type the ions are not attracted by a wire, but by an open cone. As the ions cannot decide which part of the cone to hit, they pass through the hole and form an ion beam. This ion beam can be passed on to a

See also: Electron ionization



[edit] Types of hot filament ionization gauges

  • Bayard Alpert - (sealed tube, see Review of Scientific Instruments, 1950, Vol. 21, pg.571 for original desccription)
  • Nude gauge - (uses the vacuum chamber to make a complete seal)

[edit] See also

[edit] External links

Retrieved from "http://en.wikipedia.org../../../h/o/t/Hot_filament_ionization_gauge.html"