Hot Standby Routing Protocol
From Wikipedia, the free encyclopedia
Hot Standby Routing Protocol (HSRP) is a Cisco proprietary redundancy protocol for establishing a fault-tolerant default gateway, and has been described in detail in RFC 2281. The Virtual Router Redundancy Protocol VRRP is a standards-based alternative to HSRP defined in IETF standard RFC 3768.
The protocol establishes a framework between network routers in order to achieve default gateway failover if the primary gateway should become inaccessible, in close association with a rapid-converging routing protocol like EIGRP or OSPF. By multicasting packets, HSRP sends its hello messages to the multicast address 224.0.0.2 (all routers) using UDP port 1985, to other HSRP-enabled routers, defining priority between the routers, the primary router with the highest configured priority will act as a virtual router with its own IP and MAC address, which the hosts on the local segment will be configured to use as a gateway to the destination in question. If the primary router should fail, or the link to the destination drop, the router with the next-highest priority would take over communications through alternative routes within seconds, without major interruption to network connectivity.
HSRP and VRRP are not routing protocols as they do not advertise IP routes or affect the routing table in any way.
HSRP and VRRP on some routers have the ability to trigger a failover if one or more interfaces on the router go down. This can be useful for dual branch routers each with a single serial link back to the head end. If the serial link of the primary router goes down, you would want the backup router to take over the primary functionality and thus retain connectivity to the head end.
[edit] See also
- VRRP - Standards-based alternative to HSRP
- GLBP - Cisco proprietary router redundancy solution providing load balancing
- CARP - Common Address Redundancy Protocol
