Gun-type fission weapon

From Wikipedia, the free encyclopedia

The "gun" assembly method.

Gun-type fission weapons are fission-based nuclear weapons whose design assembles their fissile material into a supercritical mass by the use of the "gun" method: shooting one piece of sub-critical material into another. Although this is sometimes pictured as two sub-critical hemispheres shot together to make a supercritical sphere, typically a core is shot into a ring-shaped receptor (such that the core cannot pass through the ring but gets stuck, and such that the combination has a compact shape). Its name is a reference to the fact that it is shooting the material through an artillery barrel as if it were a projectile. Other potential arrangements may include firing two pieces into each other simultaneously, though whether this approach has been used in actual weapons designs is unknown.

Since it is a relatively slow method of assembly, plutonium cannot be used (see below). The required amount of uranium is relatively large, and the efficiency relatively low.

The method was applied in the "Little Boy" weapon which was detonated over Hiroshima.

As far as known there are currently no gun-type weapons: advanced nuclear weapon states tended to abandon the design in favor of the implosion type weapon; new nuclear weapon states tend to develop implosion type weapons only.

Contents

[edit] Little Boy

The interior of the Little Boy weapon used against Hiroshima. The uranium-235 is indicated in red.
Enlarge
The interior of the Little Boy weapon used against Hiroshima. The uranium-235 is indicated in red.

The "gun" method is roughly how the Little Boy weapon, which was detonated over Hiroshima, worked, using uranium-235 as its enriched material. In the Little Boy design, the U-235 "bullet" had a mass of around 24 kg, and it was 16 cm long, with a diameter of 10 cm. It was powered by a cordite charge. The uranium target was about 36 kg. The hollow cylindrical shape made it subcritical. It consisted of multiple rings stacked together.

The use of "rings" had two advantages: it allowed the target to confidently remain subcritical (the hollow column served to keep the material from having too much contact with other material), and it allowed sub-critical assemblies to be tested using the same "bullet" but with just one ring.

The barrel, weighing 450 kg, was that of an anti-aircraft gun, with a 16 cm outer diameter, and the 7.5 cm inside diameter bored out to 10 cm. Its length is 180 cm, which allowed the bullet to accelerate to its final speed of 300 m/s before coming into contact with the target.

When the bullet is at a distance of 25 cm, the combination becomes critical. This means that some free neutrons may cause the chain reaction to take place before the material could be fully joined (see nuclear chain reaction).

Note that typically the chain reaction takes less than 1 μs, during which time the bullet travels only 0.3 mm. Although the chain reaction is slower when the supercriticality is low, the bullet hardly moves in this short time.

This could cause a fizzle, a predetonation which would blow the material apart before creating much of an explosion. Thus it is important that the frequency at which free neutrons occur is kept low, compared with the assembly time from this point. Also, the speed of the projectile must be sufficiently high; its speed can be increased but this requires a longer and heavier barrel.

In the case of Little Boy the 20% U-238 in the uranium had 70 spontaneous fissions per second. With the fissional material in a supercritical state, each gave a large probability of detonation: each fission creates on average 2.52 neutrons, which each have a probability of more than 1:2.52 to create another fission. During the 1.35 ms of supercriticality prior to full assembly, there was a 10% probability of a fission, with somewhat less probability of pre-detonation.

In July 1944 the laboratory abandoned the plutonium gun-type bomb ("Thin Man", shown above) and focused almost entirely around the problem of implosion.
Enlarge
In July 1944 the laboratory abandoned the plutonium gun-type bomb ("Thin Man", shown above) and focused almost entirely around the problem of implosion.

Initially the Manhattan Project gun-type effort was directed at making a gun weapon which used plutonium as its source of fissile material, known as the "Thin Man" because of its extreme length. It was thought that if a plutonium gun bomb could be created, then the uranium gun bomb would be very easy to make by comparison. However, it was discovered in April 1944 that reactor-bred plutonium (Pu-239) is contaminated with another isotope of plutonium, Pu-240, which increases the material's spontaneous neutron release rate, making predetonation inevitable. As such, a gun-type bomb is thought to only be usable with an enriched uranium bomb.

After it was discovered that the "Thin Man" program would not be successful, Los Alamos redirected its efforts into creating the implosion-type plutonium weapon: "Fat Man". The gun program switched completely over to developing a uranium bomb.

Although in Little Boy 60 kg of 80% grade U-235 was used (hence 48 kg), the minimum is ca. 20 to 25 kg, versus 15 kg for the implosion method.

The scientists who designed the "Little Boy" weapon were confident enough of its likely success that they did not field-test a design before using it in war (though they did perform non-destructive tests with sub-critical assemblies, as part of their experiments known as tickling the dragon's tail). In any event, it could not be tested before being deployed as there was only sufficient U-235 available for one device.

For a quick start of the chain reaction at the right moment a neutron trigger / initiator is used. An initiator is not strictly necessary for an effective gun design [1] [2], as long as the design uses "target capture" (in essence, ensuring that the two subcritical masses, once fired together, cannot come apart until they explode). Considering the 70 spontaneous fissions per second this only causes a delay of a few times 1/70 seconds, which in this case does not matter. Initiators were only added to Little Boy late in its design.

[edit] Proliferation and terrorism

With regard to the risk of proliferation and use by terrorists, the relatively simple design is a concern, as it does not require as much fine engineering or manufacturing as other methods. With enough highly-enriched uranium (not itself an easy thing to acquire), nations or groups with relatively low levels of technological sophistication could create an inefficient—though still quite powerful—gun-type nuclear weapon.

[edit] Comparison with the implosion method

Schematic of the gun-type method (above) and the implosion-type method (below).
Enlarge
Schematic of the gun-type method (above) and the implosion-type method (below).

For technologically advanced states the gun-type method is now essentially obsolete, for reasons of efficiency and safety (discussed below). The gun type method was abandoned by the United States as soon as the implosion technique was perfected. For some time it has still been applied for special purposes, such as artillery, see below. Other nuclear powers, such as the United Kingdom, never even built an example of this type of weapon. Besides requiring the use of highly enriched U-235, the technique has other severe limitations. The implosion technique is much better suited to the various methods employed to reduce the weight of the weapon and increase the proportion of material which fissions. South Africa built around five gun-type weapons, and no implosion type weapons. They later abandoned their nuclear weapon program altogether. They were unique in the latter and probably also in the former.

There are also safety problems with gun type weapons. For example, it is inherently dangerous to have a weapon containing a quantity and shape of fissile material which can form a critical mass through a relatively simple accident. Furthermore if the weapon is dropped from an aircraft into the sea, then the moderating effect of the light sea water can also cause a criticality accident without the weapon even being physically damaged. Neither can happen with an implosion type weapon since there is normally insufficient fissile material to form a critical mass without the correct detonation of the lenses.

[edit] US nuclear artillery

Upshot-Knothole Grable, a 1953 test of a nuclear artillery projectile at Nevada Test Site (photo depicts 280 mm gun and explosion), used a gun-type shell.
Enlarge
Upshot-Knothole Grable, a 1953 test of a nuclear artillery projectile at Nevada Test Site (photo depicts 280 mm gun and explosion), used a gun-type shell.

The gun method has also been applied for nuclear artillery shells. An advantage is that it is easier to keep the diameter small.

A US gun-type nuclear artillery weapon was tested on May 25, 1953 at the Nevada Test Site. Fired as part of Operation Upshot-Knothole and codenamed Shot GRABLE, a 280 mm shell was fired 10,000 m and detonated 160 m above the ground with an estimated yield of 15 kilotons. Thus it had approximately the same yield as Little Boy, although it weighed much less: 365 kg (vs. 4000 kg). The shell was 1384 mm long.

This was the only nuclear artillery shell ever actually fired in the US test program. It was fired from a specially built artillery piece, nicknamed "Atomic Annie". Eighty shells were produced from 1952-53. It was retired in 1957.

The W-19 was also a 280 mm gun-type nuclear shell, a longer version of the W-9. Eighty warheads were produced and the system was retired in 1963. Later versions were based on the implosion design.

[edit] See also