Film gate
From Wikipedia, the free encyclopedia
The film gate is the rectangular opening in the front of a motion picture camera where the film is exposed to light. The film gate can be seen by removing the lens and rotating the shutter out of the way. The film is held on a uniform plane at a calibrated distance in the gate by a pressure plate behind the film.
As the film passes through the gate occasionally friction can cause small slivers of celluloid to break off and stick in the side of the opening. These debris are called hairs. A "hair in the gate" will remain in front of the film and create a dark line that sticks into the edge of the film frame as the camera is filming a shot. A hair can ruin the shot and is almost impossible to fix in post production without being painted out digitally.
Because of the intractability of this problem the focus puller will open the camera and examine the gate for hairs at the end of each shot. Normally the assistant director will call out "check the gate" when the director is ready to move on to the next shot. The crew will wait until the focus puller calls out "gate is clean". If the gate is not clean, it will be cleaned with orangewood sticks and canned air and the crew will take the shot again. A decent camera crew usually checks all cameras and magazines during equipment checkout with scratch tests using fogged film rolls - this will catch out any possible scratch or hair problems caused by faulty equipment. However, a variety of other factors including environment, humidity, type of film stock, camera position, film ridging, and lacing can each be responsible for an infamous "hair in the gate". Generally, skilled crew and tested equipment makes for a rare occurrence, and it is not unheard of for assistants to go for months without seeing one, even on large-scale shoots. Oliver Stapleton recently praised his assisting team on Casanova for not having a single hair or scratch for the whole shoot, even though large portions were shot on dusty exteriors [1].
Video cameras do not have this problem, as any malfunction to the sensor will render the entire system useless. The new Arri D-20 system, however, does have removable lenses and a rotating optical shutter, which does mean that the CMOS sensor can be exposed in much the same way as a film gate and thus needs to be kept assiduously clean.
Contents |
[edit] Methods of checking the gate
There are three different commonly accepted ways to check a film gate for hairs. Some may be better for certain logistical reasons than others on particular shots, and different assistants have different preferences for which to use first. It should also be noted that if a hair is in the gate but outside of the aspect ratio being filmed (if for instance, there was a tiny speck at the bottom of a full 1.37 ratio gate but it was framed for 1.85 with common center), the hair may not always be considered enough of a problem, though usually any evidence of one is enough not to risk a lost shot.
[edit] Pulling the lens
In this method, the lens is taken off of the camera and the shutter is moved either with an automatic button (usually labeled "phase" or "dust check") or by manually inching it to an exposed position. The focus puller examines the gate with a flashlight, sometimes attached to a magnifying glass.
[edit] Through the lens
This method tends to be most useful on long lenses and zoom lenses, especially when larger lenses may be difficult to take on and off again quickly. The aperture is fully opened, with the shutter opened, focus set to infinity, and if a zoom, zoomed in as tight as possible. The lens itself acts as a large magnifying glass for the focus puller, who only needs to position the flashlight and his line of sight properly to scan the gate.
[edit] Pulling the gate
Many cameras, though not all, allow for the gate itself to be removed from the camera and examined under a light by the focus puller.
