Talk:Drilling and threading

From Wikipedia, the free encyclopedia

You have new messages (last change).

|||

This article is part of WikiProject Metalworking, an attempt to cleanup, categorize and expand Wikipedia articles related to metalworking. If you would like to participate, you can edit the article attached to this page or visit the project page, where a list of open tasks is maintained.
Drilling and threading is part of WikiProject Woodworking, a project to improve all aspects of the woodworking area. If you would like to participate, you can choose to edit this article, and to visit the project page, where you can join and see a list of open tasks to help with.


  • Drilling and threading - Unhelpful structure and lack of info, particularly on threading. --Smack (talk) 04:37, 15 March 2006 (UTC)
    • The introduction needs to say a lot more. At least one term (swarf) needs to be defined, and there are a few very important, general facts that belong in the intro.
    • The division of the entire article into two sections on wood and metal, respectively, is preposterous.
    • Drilling redirects here. It probably shouldn't. I see a potential for two separate articles: one on drilling and one on threading or tapping.
  • --Smack (talk) 03:51, 21 April 2006 (UTC)
  • Should be called Drilling and tapping. A hole is tapped but a rod is threaded. However there is no mention of the tapping process (the application of the thread) here. Not very usefull....

Peter Horn 17:58, 24 April 2006 (UTC)

Retrieved from "http://en.wikipedia.org../../../d/r/i/Talk%7EDrilling_and_threading_2c91.html"