Continuous stirred-tank reactor model

From Wikipedia, the free encyclopedia

The continuous stirred-tank reactor (CSTR) model is used to estimate the key unit operation variables when using a continuous agitated-tank reactor to reach a specified output. (See Chemical reactors.) The mathematical model works for all fluids: liquids, gases, and slurries.


Assume:

  • perfect mixing - This is a fair assumption due to the fact that merely requires the region of variable composition at the inlet area is very small when compared to the entire reactor contents and the time required to mix tank contents is very small when compared to the residence time of the reactor. This is required due to the strong dependence of the reaction rate on the concentration of the reagent species.


Integral mass balance on number of moles Ni of species i in a reactor of volume V.

[accumulation] = [in] - [out] + [generation]

1. \frac{dN_i}{dt} = F_io - F_i + V \nu_i r_i [1]

where Fio is the molar flow rate inlet of species i, Fi the molar flow rate outlet, and νi stoichiometric coefficient. The reaction rate, r, can be figured by using the Arrhenius temperature dependence. Generally, as the temperature increases so does the rate at which the reaction occurs. Residence time, τ, is the average amount of time a discrete quantity of reagent spends inside the tank.


Assume:

  • constant density (valid for most liquids; valid for gases only if there is no net change in the number of moles or drastic temperature change)
  • isothermal conditions, or constant temperature (k is constant)
  • steady state
  • single, irreversible reaction (νA = -1)
  • first-order reaction (r = kCA)


A → products


NA = CA V (where CA is the concentration of species A, V is the volume of the reactor, NA is the number of moles of species A)


2. C_A = \frac {C_Ao}{1 + k \tau } [1]

The values of the variables, outlet concentration and residence time, in Equation 2 are major design criteria.

To model systems that do not obey the assumptions of constant temperature and a single reaction, additional dependent variables must be considered. If the system is considered to be in unsteady-state, a differential equation or a system of coupled differential equations must be solved.

CSTR's are known to be one of the systems which exhibit complex behavior such as steady-state multiplicity, limit cycles and chaos.

[edit] See also

[edit] References

  1. ^ a b Schmidt, Lanny D. (1998). The Engineering of Chemical Reactions. New York: Oxford University Press. ISBN 0-19-510588-5.
Retrieved from "http://en.wikipedia.org../../../c/o/n/Continuous_stirred-tank_reactor_model.html"