Breathing gas
From Wikipedia, the free encyclopedia
Air is the most common and only natural breathing gas. Other artificial gases, either pure gases or mixtures of gases, are used in breathing equipment and enclosed habitats such as SCUBA equipment, surface supplied diving equipment, recompression chambers, submarines, space suits, spacecraft and anaesthetic machines.
Most breathing gases are a mixture of oxygen and one or more inert gases. All breathing gases are alternatives to air and have been developed to improve on the performance of air by reducing the risk of decompression sickness, reducing the duration of decompression stops, reducing nitrogen narcosis or allowing safer deep diving.
A safe breathing gas has three essential features:
- it must contain sufficient oxygen to support the life, consciousness and work rate of the breather.
- it must not contain harmful gases. Carbon monoxide and carbon dioxide are common poisons in breathing gases. There are many others.
- it must not become toxic when being breathed at high pressure such as when underwater. Oxygen and nitrogen are examples of gases that become toxic under pressure.
The techniques used to fill diving cylinders with gases other than air are called gas blending.
Contents |
[edit] Common diving breathing gases
Common diving breathing gases are:
- Air is a mixture of 21% oxygen, 78% nitrogen, and approximately 1% other trace gases; to simplify calculations this last 1% is usually treated as if it were nitrogen. Being cheap and simple to use, it is the most common diving gas. As its nitrogen component causes nitrogen narcosis it has a safe depth limit of 40 metres (130 feet) for most divers.
- Pure oxygen is mainly used to speed the shallow decompression stops at the end of a technical dive. It was much used in frogmen's rebreathers.
- Nitrox is a mixture of oxygen and air, and generally refers to mixtures which are more than 21% oxygen. It is mainly used instead of air to accelerate decompression or to decrease the risk of decompression sickness.
- Trimix is a mixture of oxygen, nitrogen and helium and is often used at depth in technical diving and commercial diving instead of air to reduce nitrogen narcosis and to increase the maximum operating depth.
- Heliox is a mixture of oxygen and helium and is often used in the deep phase of a commercial deep dive to eliminate nitrogen narcosis and to increase the maximum operating depth.
- Heliair is a form of trimix that is easily blended from helium and air without using pure oxygen. It always has a 21:79 ratio of oxygen to nitrogen; the balance of the mix is helium.
- Hydreliox is a mixture of oxygen, helium, and hydrogen and is used for dives below 130 metres in commercial diving.
- Neox is a mixture of oxygen and neon sometimes employed for in deep commercial diving. It is rarely used due to its cost. Also, DCS symptoms produced by neon ("neox bends") have a poor reputation, being widely reported to be more severe than those produced by an exactly equivalent dive-table and mix with helium.
[edit] Individual component gases
[edit] Oxygen
Oxygen (O2) must be present in every breathing gas. This is because it is essential to the human body's metabolic process, which sustains life. The human body cannot store oxygen for later use as it does with food. If the body is deprived of oxygen for more than a few minutes, unconsciousness and death result. The tissues and organs within the body (notably the heart and brain) are damaged if deprived of oxygen for much longer than four minutes.
The proportion of oxygen in a breathing gas determines the maximum operating depth, the deepest the mixture gas can safely be used:
- hypoxic mixes, strictly, contain less than 21% oxygen, although often a boundary of 16% is used, and are designed only to be breathed at depth as a "bottom gas" where the higher pressure increases the partial pressure of oxygen to a safe level. Trimix, Heliox and Heliair are used to create typical hypoxic mixes and are used in technical diving as deep breathing gases.
- normoxic mixes have the same proportion of oxygen as air, 21%. The maximum operating depth of a normoxic mix could be as shallow as 47 metres (155 feet). Trimix with between 17% and 21% oxygen is often described as normoxic because it contains a high enough proportion of oxygen to be safe to breathe at the surface.
- hyperoxic mixes have a more oxygen than 21%. Enriched Air Nitrox (EAN) is a typical hyperoxic breathing gas. Hyperoxic mixtures, when compared to air, cause oxygen toxicity at shallower depths but can be used to shorten decompression stops by drawing dissolved inert gases out of the body more quickly.
The minimum safe partial pressure of oxygen in a breathing gas is commonly held to be 16 kPa (0.16 bar). Below this partial pressure the diver may be at risk of unconsciousness and death due to hypoxia, depending on factors including individual physiology and level of exertion. When a hypoxic mix is breathed in shallow water it may not have a high enough ppO2 to keep the diver conscious. For this reason normoxic or hyperoxic "travel gases" are used at medium depth between the "bottom" and "decompression" phases of the dive.
The maximum safe partial pressure of oxygen in a breathing gas depends on exposure time, the level of exercise and the security of the breathing equipment being used. It is typically between 100 kPa (1 bar) and 160 kPa (1.6 bar) but for dives of less than three hours is commonly considered to be 140 kPa (1.4 bar), although the U.S. Navy has been known to authorize dives with a partial oxygen pressure of as much as 180 kPa (1.8 bar). At high partial pressures or longer exposures, the diver risks oxygen toxicity including a seizure similar to an epileptic fit. Each breathing gas has a maximum operating depth that is determined by its oxygen content.
Oxygen analysers are used to measure the partial pressure of oxygen in the gas mix.
Filling a diving cylinder with pure oxygen costs around five times more than filling it with compressed air. As oxygen supports combustion and causes rust in diving cylinders, it should be handled with respect when gas blending.
Oxygen is obtained by fractional distillation of liquid air.
[edit] Divox
"Divox" is oxygen. In the Netherlands, pure oxygen for breathing purposes is regarded as medicinal as opposed to industrial oxygen, such as that used in welding, and is only available on medical prescription. The diving industry "created" Divox and registered it as a trademark to circumvent the strict rules concerning medicinal oxygen thus making it easier for (recreational) scuba divers to obtain oxygen for blending their breathing gas.
[edit] Nitrogen
Nitrogen (N2) is an inert gas and the main component of air, the cheapest and most common breathing gas used for diving. It causes nitrogen narcosis in the diver, so its use is limited to shallower dives. Nitrogen can cause decompression sickness.
Equivalent air depth is often used to help design a breathing gas mix by determining the maximum nitrogen content for a particular depth of dive. Many divers find that the level of narcosis caused by a 30-metre (100-foot) dive, whilst breathing air, is a comfortable maximum. The partial pressure of nitrogen at this depth on air is 316 kPa (3.16 bar) (Fraction of nitrogen x absolute pressure = 0.79 x 400 kPa). So, what fraction of nitrogen would cause the same narcosis at 60 metres? The answer is 45% nitrogen. (316 kPa/700 kPa)
Nitrogen in a gas mix is almost always obtained by adding air to the mix.
[edit] Helium
Helium (He) is an inert gas that is less narcotic than nitrogen at equivalent pressure (in fact there is no evidence for any narcosis from helium at all), so it is more suitable for deeper dives than nitrogen. Helium is equally able to cause decompression sickness. At high pressures, helium also causes High Pressure Nervous Syndrome, which is a CNS irritation syndrome which is in some ways opposite to narcosis.
Helium fills typically cost ten times more than an equivalent air fill.
Helium is not very suitable for dry suit inflation due to its poor thermal insulation properties — helium is a very good conductor of heat (compared to air which is a rather poor, making it more of an insulator). Helium's low molecular weight (monoatomic MW=4, compared with diatomic nitrogen MW=28) increases the pitch of the breather's voice, which may impede communication. This is because the speed of sound is faster in a lower molecular weight gas, which increases the resonant frequency of the vocal cords. Helium leaks from damaged or faulty valves more readily than other gases because atoms of helium are smaller allowing them to pass through smaller gaps in seals.
Helium is found in significant amounts only in natural gas, from which it is extracted at low temperatures by fractional distillation.
[edit] Neon
Neon (Ne) is an inert gas sometimes used in deep commercial diving but is very expensive. Like helium, it is less narcotic than nitrogen, but unlike helium, it does not distort the diver's voice.
[edit] Hydrogen
Hydrogen (H2) has been used in deep diving gas mixes but is very explosive when mixed with more than about 4 to 5% oxygen (such as the oxygen found in breathing gas). This limits use of hydrogen to deep dives and imposes complicated protocols to insure that oxygen is cleared from the lungs, the blood stream and the breathing equipment before breathing hydrogen starts. Like helium, it increases the pitch of the diver's voice. See Exotic diving gases. Tech Diver Web. Retrieved on Jan 9, 2005.
[edit] Unwelcome components of breathing gases
Many gases are not suitable for use in diving breathing gases. Here is an incomplete list of gases commonly present in a diving environment:
[edit] Argon
Argon (Ar) is an inert gas that is more narcotic than nitrogen, so is not suitable as a diving breathing gas. It is sometimes used for dry suit inflation by divers whose primary breathing gas is helium-based, because of argon's good thermal insulation properties. Argon is more expensive than air or oxygen, but considerably less expensive than helium.
[edit] Carbon dioxide
Carbon dioxide (CO2) is produced by the metabolism in the human body and causes carbon dioxide poisoning.
[edit] Carbon monoxide
Carbon monoxide (CO) is produced by incomplete combustion. See carbon monoxide poisoning. Four common sources are:
- Internal combustion engine exhaust gas containing CO in the air being drawn into a diving air compressor. CO in the intake air cannot be stopped by any filter. All internal combustion engines running on petroleum fuels contain some CO, and this is a particular problem on boats, where the intake of the compressor cannot be arbitrarily moved as far as desired from the engine and compressor exhausts.
- Heating of lubricants inside the compressor may vaporize them sufficiently to be available to a compressor intake or intake system line.
- In some cases hydrocarbon lubricating oil may be drawn into the compressor's cylinder directly through damaged or worn seals, and the oil may (and usually will) then undergo combustion, being ignited by the immense compression ratio and subsequent temperature rise. Since heavy oils don't burn well - especially when not atomized properly - incomplete combustion will result in carbon monoxide production.
- A similar process is thought to potentially happen to any particulate material, which contains "organic" (carbon-containing) matter, especially in cylinders which are used for hyperoxic gas mixtures. If the compressor air filter(s) fail, ordinary dust will be introduced to the cylinder, which contains organic matter (since it usually contains humus). A more severe danger is that air particulates on boats and industrial areas, where cylinders are filled, often contain carbon-particulate combustion products (these are what makes a dirt rag black), and these represent a more severe CO danger when introduced into a cylinder.
[edit] Hydrocarbons
Hydrocarbons (CxHy) are present in compressor lubricants and fuels. They can enter diving cylinders as a result of contamination, leaks, or due to incomplete combustion near the air intake.
- They can act as a fuel in combustion increasing the risk of explosion, especially in high-oxygen gas mixtures.
- Inhaling oil mist can damage the lungs and ultimately cause the lungs to degenerate with severe emphysema.
[edit] Moisture content
The process of compressing gas into a diving cylinder removes moisture from the gas. This is good for corrosion prevention in the cylinder but means that the diver inhales very dry gas. The dry gas extracts moisture from the divers lungs while underwater contributing to dehydration, which is also thought to be a predisposing risk factor of decompression sickness. It is also uncomfortable, causing a dry mouth and throat and making the diver thirsty. This problem is reduced in rebreathers because the soda lime reaction to remove carbon dioxide puts moisture back into the breathing gas. In hot, tropical climates, open circuit diving can accelerate heat exhaustion because of dehydration.
[edit] Gas detection and measurement
Divers find it difficult to detect most gases that are likely to be present in diving cylinders because they are colourless, odourless and tasteless. Electronic sensors exist for some gases, such as oxygen analysers, helium analyser, carbon monoxide detectors and carbon dioxide detectors. Oxygen analysers are commonly found underwater in rebreathers. Oxygen and helium analysers are often used on the surface during gas blending. Chemical and other types of gas detection methods are not often used in diving.
