A2W reactor

From Wikipedia, the free encyclopedia

The A2W reactor is a naval reactor used by the United States Navy to provide electricity generation and propulsion on warships. The A2W designation stands for:

A = Aircraft carrier platform
2 = Second generation core designed by the contractor
W = Westinghouse was the contracted designer

This nuclear reactor was used in the world's first nuclear-powered aircraft carrier, the USS Enterprise (CVN-65). The four propulsion plants on Enterprise each contain two reactors, numbered 1A-1B, 4A - 4B, 2A - 2B, and 3A - 3B (numbered as they are located from fore to aft). Each propulsion plant is capable of operating on one reactor plant through most of the power range required to propel the ship at speeds in excess of 33 knots (61 km/h) (with a possible maximum speed up to approximately 35 knots; higher speeds such as the 40-50 knots sometimes rumored would rapidly become impossible due to hydrodynamic drag even if the reactors were capable of delivering enough power). Both reactors would be on-line to simultaneously provide maximum ship speed and plane launching capability.

[edit] Design and operation

The reactors are pressurized water reactors fueled by enriched U-235. Light water is used as both neutron-moderator and reactor coolant. Control rods are used to control the operation of the reactor. Extracting the rods allows the reactor to reach "criticality" - the point at which the nuclear fission reactions reach a self-sustaining level. Thereafter, steam flow (from the steam generators) regulates reactor power and the rods are "shimmed" in or out to regulate average coolant temperature.

Much of the control during steady state operation comes as a result of the negative temperature response of the water. As the water heats up, it expands and provides fewer molecules per volume to moderate the neutrons, hence fewer neutrons are slowed to the required thermal energies to sustain fission. Conversely, when the coolant water temperature decreases, its density increases and a greater number of neutrons reach the required thermal energy, increasing the number of fissions per unit of time, creating more heat. This has the effect of allowing "steam demand" to control reactor power, requiring little intervention by the Reactor Operator for changes in the power demanded by the ship's operations.

The hot water from the reactors is sent, via large pipes, into heat exchangers called steam generators. There the heat from the reactor coolant water is transferred, through tube walls, to water being fed into the steam generators from a separate feed system. In the A1W and A2W systems, the pressurized water reactor coolant is kept between 525 and 545 °F (274 and 285 °C). In the steam generators, the water from the feed system is converted to steam at 535 °F (279 °C) and a pressure of about 600 lb/in² (4 MPa). Once the reactor coolant water has given off its heat in the steam generators, it is returned, via large electric pumps (four per reactor), to the reactors to repeat the cycle.

Saturated steam at 600 lb/in² (4 MPa) is channeled from each steam generator to a common header, where the steam is then sent to the main engine, electrical generators, aircraft catapult system, and various auxiliaries. The main propulsion turbines are double-ended, in which the steam enters at the center and divides into two streams as it enters the actual turbine wheels, expanding and giving up its energy as it does so, causing the turbine to spin at high speed. The main shaft enters a reduction gear in which the high rotational velocity of the turbine shaft is stepped down to a usable turn rate for propelling the ship. The expended steam from the main engine and other auxiliaries enters condensers to be cooled into water and recycled to the feed system.

United States Naval reactors

Aircraft carrier reactors:

A1B | A1W | A2W | A3W | A4W

Cruiser reactors:

C1W

Destroyer reactors:

D1G | D2G

Submarine reactors: